UAD Powered Plug-Ins Manual v5.2 - Just Music

First material
Second
material
Blending bar
First material
selector popup
menu
Second material
selector pop-up
menu
First material
Thickness
control
Second material
Thickness control
Figure 90. RealVerb Pro Material panel
Note: While materials are used to control decay rates as a function of frequency,
the overall decay rate of the late-field reverberation is controlled from
the Timing panel (see Figure 92 on page 266).
To configure the room material and thickness:
1. Select a room material from the first (left) pop-up menu. The selected material
appears in the left side of the Material circle.
2. Adjust the thickness for the first material with the top horizontal slider:
• A default thickness of +100% yields normal, real-world decays for the material.
• Thicknesses beyond the default (up to +200%) exaggerate how the frequencies
are absorbed and reflected.
• Negative thicknesses invert the response of the material. If the material normally
absorbs high frequencies (causing them to decay quickly) and reflects
low frequencies (causing them to decay slowly), a negative thickness will instead
absorb low frequencies (causing them to decay quickly) and reflect
high frequencies (causing them to decay slowly).
• A thickness of 0% yields decay rates that are not affected by the material.
3. Select a material from the second (right) pop-up menu. The selected material
appears in the right side of the Material circle. Adjust the material thickness
with the bottom horizontal slider.
UAD Powered Plug-Ins Manual - 261 - Chapter 31: RealVerb Pro