UAD Powered Plug-Ins Manual v5.2 - Just Music

Recirculation allows both positive and negative values. The polarity refers to
the phase of the delays as compared to the original signal. If Recirculation displays
a positive value, all the delays will be in phase with the source. If it displays
a negative value, then the phase of the delays flips back and forth between
in phase and out of phase.
Damping Knob
Mix Knob
This low pass filter reduces the amount of high frequencies in the processed
signal. Higher values yield a brighter signal. Turn down this control for a
darker sound. Damping also mimics air absorption, or high frequency rolloff
inherent in tape-based delay systems.
This control determines the balance between the delayed and original signal.
Values greater than 50% emphasize the wet signal, and values less than 50%
emphasize the dry signal. A value of 100% delivers just the processed (wet)
signal, and a value of 0% delivers just the source (dry) signal. A value of 50%
delivers equal signals.
Mix allows both positive and negative values. The polarity refers to the phase
of the delays as compared to the original signal. If a positive value is displayed,
then all the delays will be in phase with the source. With a negative
value, the delayed signal is flipped 180 degrees out of phase with the source.
Mode Menu
The Mode menu determines how the Echoes are processed. The Echo Mode
differences can only be heard when the module is applied to a signal on an
insert, buss, group, or return that has a stereo output path.
Table 27. Echo Mode Menu List
Echo 1 Ping Pong 2
Echo 2 Clang 1
Echo 3 Clang 2
Ping Pong 1 Slapback
Echo On/Off
Button
Enables or disables Echo. You can use this switch to compare Echo settings to
that of the original signal or bypass Echo to reduce UAD DSP load.
UAD Powered Plug-Ins Manual - 351 - Chapter 38: Nigel