UAD Powered Plug-Ins Manual v5.2 - Just Music

Pultec Latency
The Pultec and Pultec-Pro plug-ins introduce an additional 13 samples of delay
due to upsampling when the session sample rate is below 100kHz. This
additional latency does not occur at sample rates above 100kHz. You may
enter a value of 13 in the “Samples” parameter in DelayComp or TrackAdv
to compensate. See “Compensating Upsampled Plug-Ins” on page 97 for
more information.
Note: Compensating for Pultec and Pultec-Pro is not required if the host application
supports full plug-in delay compensation throughout the signal path, or
when it is used on outputs. See “Host PDC Implementation” on page 90.
Pultec EQP-1A Screenshot
Figure 68. The Pultec EQP-1A Program Equalizer plug-in window
Pultec EQP-1A Controls
The EQP-1A can control three frequency ranges simultaneously, using three
groups of interacting parameters.
The first group controls the low frequencies and has three controls: boost, attenuation,
and frequency select. The second group controls the high frequencies
and has three controls: boost, bandwidth, and frequency select. The third
group also controls the highs and has two controls: attenuation amount and
frequency select.
The placement and grouping of the sections and their related controls are
shown in Figure 69 on page 214.
UAD Powered Plug-Ins Manual - 213 - Chapter 23: Pultec and Pultec-Pro