UAD Powered Plug-Ins Manual v5.2 - Just Music

Dual Mode
In Dual mode (dual-mono mode), the left and right parameters can be independently
adjusted so that each side of the stereo signal can have different
EQ settings. Note that this mode is infrequently used during mastering because
phase, imaging, and level inconsistencies may be induced in the resulting
stereo signal.
Mode Selection
Any of the below methods may be used to modify the Mode value:
• Click the Stereo button to cycle through modes A and B
• Click the Dual button to activate dual-mono mode
• Click the indicator light above each mode
• Click+hold+drag the indicator light above each mode.
Parameter Copy
Buttons
The Parameter Copy buttons provide an easy method for copying
parameter values. The behavior of the buttons is determined
by the current operating mode of Precision Equalizer.
Note: The values that existed at the destination before copying are lost.
Stereo Mode
When in Stereo mode (see “Stereo Mode” on page 196), clicking A > B copies
the left AND right parameter values from parameter set A to parameter set
B, and clicking the A < B button copies all the values from parameter set B to
parameter set A.
This feature is useful when you want to make an EQ change to a stereo signal
while maintaining the original values so the two settings can be easily compared.
Note: The high-pass filter parameter is global per preset and is not affected by
this control.
Parameter Copy in Dual Mode
When in Dual mode, the A and B buttons behave as left and right channel
copy buttons. Clicking A > B copies all the values from the left channel parameters
to the right channel parameters, and clicking A < B copies all the values
from the right channel parameters to the left channel parameters.
UAD Powered Plug-Ins Manual - 197 - Chapter 21: Precision Equalizer