UAD Powered Plug-Ins Manual v5.2 - Just Music

Harrison 32C EQ and Harrison 32C SE Controls
Power
The Power switch determines whether the plug-in is active. Click the
button to toggle the state. When the Power switch is in the Off
(lighter) position, plug-in processing is disabled and UAD DSP usage
is reduced.
Power LED
Phase
Cut Filters
The Power LED is illuminated when the plug-in is active.
The Phase button inverts the signal by adding a 180° phase shift.
The signal is inverted when the button is engaged (darker). Leave
the button inactive (lighter) for normal phase.
In addition to the four-band EQ, the
Harrison 32C offers two cut filters, one
each for low and high frequencies. The
slope of the cut filters is 12dB per octave.
Cut Enable
The high and low pass filters are engaged
with the Cut Enable switch. The
Cut Filters are active when the “In” switch is engaged (darker). When the Cut
Filters are engaged, circuit coloration is modeled even when set to “zero cut”
frequency values (25Hz and 20kHz respectively).
The Cut Enable “In” switch is to the left of the EQ “In” switch on the graphical
interface.
High Pass (low cut)
This control determines the cutoff frequency for the high pass filter. The available
range is 25Hz to 3.15kHz.
Low Pass (high cut)
This control determines the cutoff frequency for the low pass filter. The available
range is 1.6kHz to 20kHz.
UAD Powered Plug-Ins Manual - 240 - Chapter 27: Harrison 32C EQ