TO 1-1-700 - Robins Air Force Base
TO 1-1-700 - Robins Air Force Base
TO 1-1-700 - Robins Air Force Base
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>TO</strong> 1-1-<strong>700</strong><br />
Table 12-1. Sealing Compounds - Continued<br />
Specification Types Available Properties Intended Use<br />
Av-Dec® HiTak® TufSeal<br />
Polyurethane Tape Sealant (part<br />
No. HT3000-XXX)<br />
Av-Dec® Self-Leveling<br />
Green (part No. HT 3326-5-<br />
XXX) and Thixoflex Orange<br />
Injectable (part No. TF2219)<br />
Sealants<br />
-100 for fay surfaces<br />
≤1 inch wide<br />
-150 for fay surfaces<br />
>1 inch up to 1.5<br />
inches wide<br />
-200 for fay surfaces<br />
>1.5 inches up to 2<br />
inches wide<br />
Self Leveling Green<br />
- for filling voids and/<br />
or cavities on horizontal<br />
surfaces where a<br />
self leveling liquid may<br />
be used; supplied in<br />
either 50cc (-050) or<br />
200 (-200) cartridges;<br />
Thixoflex Orange -<br />
for filling voids/cavities<br />
on horizontal, vertical,<br />
or overhead<br />
surfaces where a paste<br />
material is required;<br />
supplied in 50cc cartridges.<br />
Preformed gasket tape with adhesive<br />
on one side and a permanent<br />
Teflon film baking on the opposite<br />
side;<br />
No mixing, masking, or curing<br />
required;<br />
Service Temp: -85 ºF to +275 ºF<br />
(-65 ºC to +135 ºC);<br />
Peel Strength: 2-5 lb./in. width<br />
adhesive side only, the other side<br />
has a permanent Teflon film backing;<br />
No corrosion inhibitors;<br />
Resists water, deicing fluids, fuel,<br />
oil, and hydraulic fluid.<br />
Two component sealants; both are<br />
supplied in dual syringes containing<br />
the required amounts of resin<br />
and hardener for mixing on site;<br />
Mixing and dispensing is accomplished<br />
with accessories obtained<br />
from the vendor per the vendor's<br />
instructions;<br />
Service Temp: -60 ºF to +260 ºF<br />
(-51 ºC to +127 ºC) either type;<br />
Peel Strength: both 1-4 lb./in.<br />
width;<br />
No corrosion inhibitors;<br />
Resists water, deicing fluids, fuel,<br />
oil, and hydraulic fluid.<br />
For fay surface sealing of<br />
non-permanent structure<br />
such as access and inspection<br />
panels/covers to prevent<br />
fluid entry into the faying<br />
surface areas and the cavities<br />
over which the panels/covers<br />
are installed. The<br />
Teflon® backing is highly<br />
abrasion resistant and permits<br />
slight movement of the<br />
covers without damaging the<br />
structure to which it is<br />
attached. The tape is very<br />
durable, so it may be reused<br />
many times once it is<br />
installed, and damaged sections<br />
are easily repaired as it<br />
has very good adhesion to<br />
itself.<br />
The Self Leveling Green<br />
sealant is intended to fill<br />
void/cavities on horizontal<br />
surfaces to prevent fluids<br />
from accumulating in them<br />
and causing corrosion while<br />
still being easily removed for<br />
required inspections and/or<br />
operational use. Also useful<br />
to fill cavities around<br />
antenna connectors.<br />
The Thixoflex Orange<br />
sealant is intended for filling<br />
the same voids/cavities as<br />
above as well as those on<br />
vertical and overhead surfaces<br />
while still being easily<br />
removed for required inspections<br />
and/or operational use.<br />
12-10