HQ Pro-Stitcher User Manual - Handi Quilter

Setting up the New Carriage
1. With the HQ Pro-Stitcher carriage set properly
on the frame system, untie the black twist ties that
are binding the black cables in a loop. Drape the
black cables over the back of the carriage as shown in
Figure 11.
2. Plug one branch of the new “Y” power cord
(Page 3, I) into the power supply located toward the
rear of the carriage (Figure 12). Route the power
cord as shown in Figure 11. It is also permissible to
have the power cord extend directly out the side of
the carriage rather than over the top of the carriage.
3. With the X-axis engagement lever shifted into the
lowest position, verify that the white gear at the front
of the carriage fully engages with the blue rack that
was previously installed.
Plug
Figure 12
a. If the white gear fails to lower enough with the
front disengagement lever in its lowest position, you
will need to adjust the black X-axis lever bracket to
allow the X-axis engagement lever to drop a little
lower. To do this, loosen the two 4mm Allen bolts
and pivot the bracket downward until the white gear
is pressing firmly on the blue rack, then re-tighten
the two bolts (Figure 13).
b. Move the carriage along the length of the table to
double-check the placement of the blue rack. Make
adjustments to the blue rack as necessary.
Adjust only
if necessary
Figure 13
Page 8
Figure 11
HQ Pro-Stitcher User Manual