HQ Pro-Stitcher User Manual - Handi Quilter

6. If the user only wishes to repeat in width, there is
no need to enter anything in the “Height” box. Simply
enter the desired width in the “Width” box and
press the “Repeat Width” button (Figure 29). The
same can be done for repeating only height using the
repeat height button.
7. If the size of the defined area is smaller than one
instance of the loaded pattern, a message will pop up,
instructing the user to enter a larger value
(Figure 30). Press the “Accept” button and correct
the height and/or width and try again. In Figure
30, the height entered is 3 inches, but the height of
the pattern (as can be seen at the top of the screen)
is 5.37 inches. The error pops up because the Pro-
Stitcher cannot fit this pattern into the desired size
box without shrinking the pattern.
Figure 29
8. Press the “Done” button to save the repeated pattern
and return to the “Repeat” menu screen.
9. If the final size after using the “Repeat Within
Area” function does not match the desired size, go
back to the “Resize” screen and resize the entire
repeated pattern to the desired size.
Figure 30
www.HandiQuilter.com/ProStitcher Page 51