HQ Pro-Stitcher User Manual - Handi Quilter

If the “Auto Find” option box is selected, the user
just has to move the quilting machine back to the
desired resume point on the quilt (i.e., where the
thread broke). The HQ Pro-Stitcher will locate the
closest point on the pattern to the current position of
the quilting machine (Figure 48). It may be necessary
to toggle the “Enable Motors” button prior to
moving the machine. It is also helpful to toggle back
to lock the machine in position once the desired
location is reached.
The final way to set a new starting position is to
manually enter the line number in the “Current
Line” box located under the “Auto Find” option
(Figure 48). This can be useful if the user has a pattern
that she wishes to repeatedly start from a point
other than the actual start point. The user must first
determine what that line number is by using one of
the above methods and then take note of the “Current
Line” value. Then the user can simply enter
that number into the box using the pop-up number
pad.
Figure 47
In any of the above cases, when the white segment
is at the appropriate location in the pattern, the user
should press the “Start Here” button. The HQ Pro-
Stitcher will warn the user that the machine is about
to move to that location.
Make sure the needle is in the “Up” position and
press the “Accept” button to continue or the “Cancel”
button to make additional changes or cancel the
process. After pressing “Accept,” the machine will
move to the new start point and return the user to
the “Pause Screen.” The HQ Pro-Stitcher is now set
to resume at the beginning of the white line segment
indicated in the pattern.
Figure 48
Page 62
HQ Pro-Stitcher User Manual