HQ Pro-Stitcher User Manual - Handi Quilter

X-Rack Installation
1. Make sure the front white track is mounted to
the table with the 3M Command Strips (Page 16, N)
that have been provided (unless the front track is
already mounted to the table). Use the carriage as a
guide to make sure there is no binding once the front
track is mounted to the table.
2. Remove the blue 12-foot rack (A) and the HQ
Pro-Stitcher carriage (E) from the box. Cut the cable
ties from the front of the carriage (Figure 2).
3. Starting at one end of the table, begin mounting
the blue rack to the table. Peel back just a few
inches of the protective layer of the tape. Position
the blue rack using the wooden alignment block (M)
as a guide. The wood block should be laid flat on
the table top, butted against the inside edge of the
front white track (Figure 3). The blue rack then butts
against the opposite side of the block so the blue rack
is mounted 2” away from the front white track.
Figure 2
The block should be flat on the table and not on top
of the blue rack or the white track. Press down on
the blue rack to stick it firmly to the table. Pull the
pink protective layer from the back side of the rack
while shifting the block down the length of the table
until about two feet of the rack have been mounted.
4. Place the HQ Pro-Stitcher carriage on the frame
and verify that the front white gear is aligned with
the blue rack mounted on the table top.
Front of Frame
Figure 3
Page 18
HQ Pro-Stitcher User Manual