HQ Pro-Stitcher User Manual - Handi Quilter

7. Carefully lift the quilting machine and place it
on the carriage so the wheels engage the white carriage
tracks, making sure not to set the wheels on
top of the stitch regulator cable (this is easier to do
with two people – one at each end of the quilting
machine). The stitch regulator cable should be laying
across the carriage in such a manner that it ends
up between the front and rear wheels of the quilting
machine when it is placed on the carriage.
8. For HQ Sixteen only: Plug the Stitch Regulator
Adapter Board (Page 16, Q) into the Y-axis stitch
regulator encoder (Figure 17).
9. Plug the middle connector on the gray stitch
regulator cable into the Y-axis stitch regulator encoder
(the stitch regulator encoder mounted to the
rear machine wheel).
10. To prevent the stitch regulator cable from
dragging across the motor assemblies during operation,
route the final section of the stitch regulator
cable around the back of the quilting machine and
plug the 9-pin D-sub connector into the C-Pod
(Figure 18).
Figure 17
Figure 18
Page 26
HQ Pro-Stitcher User Manual