IntelliStation E Pro User Guide Professional ... - FTP Directory Listing

More documents

Recommendations

Info

� Diskette Eject Button: Push this button to release a diskette from the drive. � Diskette-Drive Light: When this light is on, it indicates that the diskette drive heads are being positioned or that your computer is reading from or writing to a diskette. � CD-ROM Drive Light: When this light is on, it indicates that the CD-ROM drive is reading the CD. � CD-ROM Eject Button: Push this button to release the CD-ROM tray for inserting or removing a CD-ROM. 12 Using Your IntelliStation E Pro
Starting Your Computer Before you begin Please observe the following: � When the power cord is first plugged in, the computer appears to power on for a few seconds, and then power off. This is a normal sequence to enable the computer to self initialize. � What you see and hear when you start up your computer depends upon settings in the Configuration/Setup Utility program. See “Settings that Affect the Startup Procedure” on page 16 for more information. � If you plan to start your computer over a network, see “Starting Your Computer Over a Network” on page 17. To start your computer 1. Turn on all devices connected to the computer. 2. Press and release the power switch on your computer. If you have changed settings for features (such as passwords or the startup sequence) in the Configuration/Setup Utility program, see “Settings that Affect the Startup Procedure” on page 16 for important information. If you have not changed any settings in the Configuration/Setup Utility program, the following actions occur: � The video BIOS is installed. � The IBM logo appears on the screen. � The power-on self-test (POST) is performed. If POST detects a problem, you hear multiple beeps (or no beep) and an error message appears on the screen. Write down any error code numbers and descriptions. � The computer allows you to enter the Configuration/Setup Utility program (by pressing F1) or run a fast POST (by pressing Esc). � If you have a SCSI model, the SCSI BIOS is installed. 3. A DHCP (Dynamic Host Configuration Protocol) request is sent to the network, and one of the following events occurs: � If you are properly connected to a network, a DHCP server dynamically assigns an IP (internet protocol) address to your computer and then loads a startup image onto your computer. � If the DHCP request is unsuccessful, the following message appears: Chapter 4. Operating Your Computer 13
Page 1: IntelliStation E Pro User Guide Pro
Page 4 and 5: Note Before using this information
Page 6 and 7: Video Device Drivers . . . . . . .
Page 8 and 9: Getting Help Online . . . . . . . .
Page 10 and 11: Danger To avoid a shock hazard, do
Page 12 and 13: Related Information The following d
Page 14 and 15: xii Using Your IntelliStation E Pro
Page 16 and 17: Features at a Glance For a list of
Page 18 and 19: Euro Sign Support Information The E
Page 20 and 21: Connecting Cables 6 Using Your Inte
Page 22 and 23: Turning on Power Turn on the monito
Page 24 and 25: Glare and Lighting Position the mon
Page 28 and 29: No IP address found for DHCP or BOO
Page 30 and 31: Settings that Affect the Startup Pr
Page 32 and 33: Using Mouse Features The mouse supp
Page 34 and 35: Using a CD-ROM Drive All IntelliSta
Page 36 and 37: Loading a CD into a Vertically Posi
Page 38 and 39: � To load a CD into a CD-ROM with
Page 40 and 41: Using Video Features Your computer
Page 42 and 43: Using System-Management Features No
Page 44 and 45: DMI BIOS The BIOS (basic input outp
Page 46 and 47: � Desktop Management (DM) BIOS 2.
Page 48 and 49: Important Record the serial number
Page 50 and 51: There is an extra measure of protec
Page 52 and 53: Erasing a Lost or Forgotten Adminis
Page 54 and 55: 40 Using Your IntelliStation E Pro
Page 56 and 57: Starting and Using the Program To s
Page 58 and 59: In the Configuration/Setup Utility
Page 60 and 61: Instructions for Most Frequently Us
Page 62 and 63: Off In password prompt Off mode (so
Page 64 and 65: the system board. Refer to “Erasi
Page 66 and 67: Important Information If you have s
Page 68 and 69: Deleting an Administrator Password:
Page 70 and 71: Setting Remote Administration Enabl
Page 72 and 73: - Disable: In this mode, the monito
Page 74 and 75: Configuration/Setup Utility Options
Page 76 and 77:
Devices and I/O Ports If you select
Page 78 and 79:
Item Description Video Setup Video
Page 80 and 81:
Item Description Keyboardless Opera
Page 82 and 83:
Item Description Secure IDE Devices
Page 84 and 85:
Item Description PCI Control PCI Pa
Page 86 and 87:
Item Description DMA Resources The
Page 88 and 89:
Item Description Automatic Power On
Page 90 and 91:
To Configure Select Comments Serial
Page 92 and 93:
To clean the screen surface, wipe i
Page 94 and 95:
3. Shut down the operating system a
Page 96 and 97:
Electrical Safety CAUTION: Electric
Page 98 and 99:
Available Options Following are som
Page 100 and 101:
Locating Components The following i
Page 102 and 103:
Identifying Parts on the System Boa
Page 104 and 105:
Disconnecting Cables and Removing t
Page 106 and 107:
5 Lift the back edge and slide the
Page 108 and 109:
The following tools are available t
Page 110 and 111:
2. If you have set a power-on passw
Page 112 and 113:
POST Message Charts The computer mi
Page 114 and 115:
POST Message Description 164 A chan
Page 116 and 117:
POST Message Description 20X A fail
Page 118 and 119:
POST Message Description 178X A fai
Page 120 and 121:
POST Message Description 1802 A PCI
Page 122 and 123:
POST Message Description 1880 A Plu
Page 124 and 125:
Page 126 and 127:
Page 128 and 129:
POST Beep Codes One beep and the ap
Page 130 and 131:
Troubleshooting Charts You can use
Page 132 and 133:
Monitor Problems Action Wavy, unrea
Page 134 and 135:
Monitor Problems Action Blank scree
Page 136 and 137:
Memory Problems Action The amount o
Page 138 and 139:
Parallel Port Problems Parallel por
Page 140 and 141:
IBM Enhanced Diagnostics IBM provid
Page 142 and 143:
CoSession Remote CoSession Remote i
Page 144 and 145:
130 Using Your IntelliStation E Pro
Page 146 and 147:
� IBM Hardware Repair - If the pr
Page 148 and 149:
- In Vancouver, call 604-664-6464.
Page 150 and 151:
Getting Help by Telephone During th
Page 152 and 153:
� In Australia and New Zealand, c
Page 154 and 155:
Warranty upgrades in the U.S. inclu
Page 156 and 157:
Device Records Use the following ta
Page 158 and 159:
Page 160 and 161:
The following figure illustrates th
Page 162 and 163:
Other error messages that might occ
Page 164 and 165:
Error Code Description M31 TFTP can
Page 166 and 167:
IBM Statement of Limited Warranty f
Page 168 and 169:
Production Status Each IBM Machine
Page 170 and 171:
Items Not Covered by Warranty IBM d
Page 172 and 173:
Part 2 - Worldwide Country-Unique T
Page 174 and 175:
IRELAND: Extent of Warranty: The fo
Page 176 and 177:
Notices References in this publicat
Page 178 and 179:
Electronic Emission Notices Federal
Page 180 and 181:
Power Cord Notice For your safety,
Page 182 and 183:
Page 184 and 185:
circulation, air 10 cleaning compac
Page 186 and 187:
Matrox Millennium II AGP graphics a
Page 188:
starting computer 13 startup sequen
show all

IntelliStation E Pro User Guide Professional ... - FTP Directory Listing

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?