User Manual - Hasselblad.jp

More documents

Recommendations

Info

12 Film magazines The 503CW and 503CWD accepts film magazines allowing for greater freedom and a useful alternative to digital capture . The A12 film magazine accepts all 120 size films and produces a 6 x 6cm image. It is easy to use and can be pre-loaded for rapid workflow. They provide the opportunity to vary the type of film used and can be quickly and easily switched mid-film without losing any frames. There are a number of reasons why using film might either be preferable or even necessary for digital photographers too. For example you might want the specific results you know that a certain film emulsion can produce or you might want to use very long exposure times, etc. A magazine also functions as an emergency battery-free back up to a digital capture unit. Also, remember that a 6 x 6 cm film magazine use will allow you to exploit the full focal length of your lenses. Operation of the magazines is not difficult but pay particular attention to the section on loading. Go through the procedure one step at a time and practice a little until you feel confident. Note especially which way round the spool of film is placed and the positioning of the backing paper under the clamp bar. The film is automatically advanced frame-by-frame in the magazine by the camera winding mechanism and consequently only when attached to the camera body. Therefore when separated, the magazine and camera body could become unmatched. This can be determined by checking the magazine status indicator or by the winding crank status. A B C D E Parts & components A. Magazine slide I. Film take-up spool B. Film load indicator J. Grooved take-up knob C. Film holder key K. Film clamp D. Magazine slide holder L. Film holder number E. Film tab holder M. Spool clamp bar F. Film winder crank N. Film supply spool G. Frame counter O. Film load index H. Film advance indicator P. Film load index for Ilford black & white film only F G H I J K L M N Loading the magazine The magazine can be loaded on, or off the camera. If it is to be loaded off the camera, then the magazine slide must be inserted first. In either case, when inserting the slide ensure that its flat side is towards the rear (see detail in illustration 4) as this facilitates the removal of the film holder. P O 66
1 2 3 4 5 6 7 8 9 10 501CM..19 980505 COPYRIGHT © 1998 ANDERS ENGSTRÖM ANDERS ENGSTRÖM, ILLUSTRATÖR Östra vägen 46 430 91 HÖNÖ tel/fax 031-96 84 64 anders@aeillustr.se 501CM..21 980429 COPYRIGHT © 1998 ANDERS ENGSTRÖM ANDERS ENGSTRÖM, ILLUSTRATÖR Östra vägen 46 430 91 HÖNÖ tel/fax 031-96 84 64 anders@aeillustr.se 501CM..23 980429 COPYRIGHT © 1998 ANDERS ENGSTRÖM ANDERS ENGSTRÖM, ILLUSTRATÖR Östra vägen 46 430 91 HÖNÖ tel/fax 031-96 84 64 anders@aeillustr.se 501CM..25 980429 COPYRIGHT © 1998 ANDERS ENGSTRÖM ANDERS ENGSTRÖM, ILLUSTRATÖR Östra vägen 46 430 91 HÖNÖ tel/fax 031-96 84 64 anders@aeillustr.se 501CM..27 980429 COPYRIGHT © 1998 ANDERS ENGSTRÖM ANDERS ENGSTRÖM, ILLUSTRATÖR Östra vägen 46 430 91 HÖNÖ tel/fax 031-96 84 64 anders@aeillustr.se 501CM..26 980429 501CM..22 980429 501CM..26 980429 COPYRIGHT © 1998 ANDERS ENGSTRÖM ANDERS ENGSTRÖM, ILLUSTRATÖR Östra vägen 46 430 91 HÖNÖ tel/fax 031-96 84 64 anders@aeillustr.se Step-by-step film loading 1–8 501CM..20 980429 Follow the procedure below in the correct order. 1. Fold out the film holder key. 2. COPYRIGHT Turn © the 1998 key ANDERS counter-clockwise ENGSTRÖM and withdraw the film holder ANDERS (magazine ENGSTRÖM, ILLUSTRATÖR insert). Östra vägen 46 430 91 HÖNÖ 3. Place an empty take-up spool under the grooved knob of the tel/fax 031-96 84 64 anders@aeillustr.se spool clamp bar. Insert a roll of film under the other end of the bar, turned the same way as in the illustration. Be sure to remove all of the paper band surrounding a new roll of film. 4. Turn the film holder key clockwise to open the film clamp. Pull 8 -10 cm (3 - 4 in.) of paper backing off the film roll and slide COPYRIGHT © 1998 ANDERS ENGSTRÖM the edge under the clamp. 5. Insert the tongue of the backing paper into the slot in the ANDERS ENGSTRÖM, ILLUSTRATÖR Östra vägen 46 430 91 HÖNÖ tel/fax 031-96 84 64 anders@aeillustr.se take-up spool. 503CW..19C.blå 960828 6. Turn the grooved knob clockwise until the arrow on the paper backing is aligned opposite the triangular index (or oblong index with Ilford black & white film, see ‘Magazine tips’) on the spool clamp bar, but no further. COPYRIGHT © 1996 ANDERS ENGSTRÖM 7. Turn the film holder key counter-clockwise and insert the film holder into the magazine. Ensure that it is correctly positioned. Turn the film holder key clockwise to lock the film holder in the magazine and then fold the key back into place. ANDERS ENGSTRÖM, ILLUSTRATÖR Östra vägen 46 430 91 HÖNÖ tel/fax 031-96 84 64 anders@aeillustr.se COPYRIGHT © 1998 ANDERS ENGSTRÖM 8. Fold out the film crank and rotate it clockwise about ten turns until it stops. Then turn it counter-clockwise and fold it in. The figure (1) will now be displayed in the automatic frame-counter window indicating that the magazine is loaded and ready ANDERS ENGSTRÖM, ILLUSTRATÖR Östra vägen 46 430 91 HÖNÖ for use. tel/fax 031-96 84 64 anders@aeillustr.se Magazine load status 9 In the centre of the film holder key there is a crescent-shaped indicator window that shows white when the magazine is freshly loaded. It gradually changes to red as the film is wound through. An all red indicator shows that either the film is used up or that the magazine is empty. Removing film from the magazine 10 When the last frame has been exposed and wound on, the magazine blocks the camera for further release. Wind off the film by folding out the film winding crank, and rotate it clockwise until you can feel the film leaving the supply spool. You can now withdraw the film holder from the magazine and remove the exposed film. The frame counter is automatically reset when the film holder is withdrawn from the magazine. 11 501CM..29 980429 Film tab holder 11 The end tab of the film pack can be inserted in the holder on the back of the magazine as a reminder of the kind of film that has been loaded into the magazine. COPYRIGHT © 1998 ANDERS ENGSTRÖM ANDERS ENGSTRÖM, ILLUSTRATÖR Östra vägen 46 430 91 HÖNÖ tel/fax 031-96 84 64 anders@aeillustr.se 67
Page 1 and 2:
User Manual Hasselblad 503CW/503CWD
Page 3 and 4:
Welcome to HASSELBLAD ! The Hasselb
Page 5 and 6:
FlexColor and Phocus workflow FlexC
Page 7 and 8:
Before you start Leave protective c
Page 9 and 10:
3 2 1 27 4 26 25 24 22 23 20 21 19
Page 11 and 12:
2 Camera Body This section describe
Page 13 and 14:
3 Lenses The 503CW/503CWD is compat
Page 15 and 16: 7 Interlocked shutter speed /apertu
Page 17 and 18: 3 4. Grip the lower edge of the mag
Page 19 and 20: The CFVII is also designed to also
Page 21 and 22: Power indicator 6 Glows orange to i
Page 23 and 24: General Using the menu is very simi
Page 25 and 26: Simple introductory overview of men
Page 27 and 28: Storage & Shooting Image storage mo
Page 29 and 30: Older digital capture units in the
Page 31 and 32: Medium-type icon (Compact Flash) Me
Page 33 and 34: Using Instant Approval Architecture
Page 35 and 36: Note that you can set the camera to
Page 37 and 38: 1 2 Zooming in for more detail The
Page 39 and 40: ISO setting White balance Current s
Page 41 and 42: Deleting images − general Delete
Page 43 and 44: Menu structure Items on the main me
Page 45 and 46: 11a 2a White balance / Grey Balance
Page 47 and 48: Browse The browse filter complement
Page 49 and 50: 1 3 2 MENU > STORAGE The Storage m
Page 51 and 52: 4 5 4. You now return to the main m
Page 53 and 54: 1 2 3 4 5 FORMAT The digital cap
Page 55 and 56: 1 2 3 4 DEFAULT APPR. LEVEL The I
Page 57 and 58: MENU > SETTINGS > User Interface By
Page 59 and 60: The exposure time set on the digita
Page 61 and 62: 1 2 Delay: Controls the amount of t
Page 63 and 64: 1 2 Setting EXPOSURE TIME and CAPTU
Page 65: 1 2 MENU > SETTINGS > About Occas
Page 69 and 70: Double exposure with film Double (o
Page 71 and 72: Viewfinder indicator - (503CW / 503
Page 73 and 74: 14 Accessories Apart from the acces
Page 75 and 76: Tripod quick-coupling The coupling
Page 77 and 78: 6. When reattaching the digital cap
Page 79 and 80: Technical specifications continued
Page 81 and 82: Further reading World class results
show all

User Manual - Hasselblad.jp

Create successful ePaper yourself

Delete template?

Save as template?