4 cylinders + 6 cylinders 4 cylinders + 6 cylinders - Steyr Motors

ToC
01 ENGINE
SERVICE MANUAL MARINE ENGINES
01.06.04 Replace oil pump
(front ring carrier)
Preparation: dismantle engine housing, 01.06.01.
remove timing belt
remove vibration damper
1 Pull of timing belt sprocket by means of special tool
No. 2300636/0 (ill.1).
06.04 ill.1
2 Loosen 6 hexagon screws (SW13) (ill.2), remove oil
pump housing.
õ
06.04 ill.2
ATTENTION: Replace radial shaft sealing ring (ill.3/
pos.1) in oil pump housing. Mount oil
pump housing, and insert radial shaft
sealing ring with special tool No.
VR00118/0.
2
NOTE:
Check sealing ring (ill.3/pos.2) on oil
pump housing for damage; exchange
if necessary. (wet new sealing ring
with surface sealing agent LOCTITE
5910)
1
Apply LOCTITE 509 to flange surface
to front main bearing block and oil
pump (front ring carrier)
06.04 ill.3
Secure the 6 hexagon screws (ill.2)
with thread protection LOCTITE 243
and tighten with a torque of
23 Nm +/-2.
Page ENGINE - 72 Z001019/0_6_July 2008