4 cylinders + 6 cylinders 4 cylinders + 6 cylinders - Steyr Motors

ToC
ELECTRICAL SYSTEM
SERVICE MANUAL MARINE ENGINES
06.10.03 Calibration of rack position
This procedure must be carried out if any of the following has been done:
- Control solenoid has been disassembled or replaced, refer to 03. 08. 01.
- Rack position sensor has been disassembled or replaced, refer to 03. 08. 03.
- Engine control unit has been replaced.
- Rack or linkage lever have been replaced or loosened.
E
1
10.03 ill.1
F
D
C
B
A
10.03 ill.2
NOTE:
Ensure that the ignition is turned off.
1 Remove threaded pin from position A (ill. 1).
2 Manually move rack (ill.1/B) forward until borehole (ill.1/C) is over tapped hole (ill.1/D) and fix
with threaded pin. The pin must be fastened hand tight and sit correctly in the rack, see ill. 2.
above.
3 Turn on ignition,rack position will be automatically stored in the ECU A5.
Storage process will take approx. 20 sec.
4 Turn off ignition.
5 Loosen threaded pin and screw it into rear bulkhead wall (ill.1/A).
NOTE:
If storage in ECU A5 was unsuccessful, error code 56 will be detected.
Refer to Error Codes.
NOTE:
The rack position sensor is magnetism
sensitive. All external magnets must
be kept away as the may disturb the
sensor.
Page ELECTRICAL SYSTEM - 82 Z001019/0_6_July 2008