4 cylinders + 6 cylinders 4 cylinders + 6 cylinders - Steyr Motors

More documents

Recommendations

Info

ToC ELECTRICAL SYSTEM SERVICE MANUAL MARINE ENGINES 06.10.05.05 Check oil pressure sensor B18 and/or wiring X18 X18/A 31100-10 X18/B 15100-07 X18/C 60117-01 On account of the sensor's integrated electronic system,only the supply voltage and/or the output signal can be measured. Make sure that with disconnected plug X15 and ignition "ON" the error code 32 HiLPS is stored --> At completion of check, cancel the error code; refer to 06.06.04 Use a standard voltmeter / multimeter to mesure the supply voltage and/or the resistance. Supply voltage + 5V +/- 0,4V ignition ON main relay K27 active measuring point GND on X18/A against + 5V on X18/B Continuity from X18/C to control unit X5/10 max. resistance 2 ohms Output signal depending on pressure; see diagram Remove B18 and admit pressure when X18 is connected; max. 5 bars measuring point X18/C --> X18/B 10.05 ill.10 voltage via pressure voltage (V) voltage pressure (bar) 10.05 ill.11 Page ELECTRICAL SYSTEM - 90 Z001019/0_6_July 2008
ToC SERVICE MANUAL MARINE ENGINES ELECTRICAL SYSTEM 06.10.05.06 Check oil pressure sensor "VDO-instrument" (option B19) NOTE: If oil pressure is questionable, - check oil level before starting the engine. - check minimum oil pressure. Minimum oil pressure Idle 1 bar 1000 2 bar 2500 and above 4 bar Check minimum oil pressure: Start engine and let engine run at idle speed, 1000 and 2500 r.p.m. Check tachometer and and oil pressure gauge. Record oil pressure value for idle speed, 1000 and 2500 r.p.m. If values are not appropriate, check the oil pressure gauge before checking the oil pressure sensor. To check the oil pressure gauge, disconnect cable from sensor, turn on ignition key and shortly put the sensor cable to ground connection. If gauge functions properly, the pointer will shortly deflect to high values. If there is no malfunction of the gauge, replace the oil pressure sensor. Check of oil pressure sensor: 1. To check the oil pressure sensor, disconnect the sensor cable and connect an ohmmeter to sensor terminal and sensor. 2. Check resistance at zero pressure; resistance should be 240 Ohm ± 10 %. - If resistance is out of tolerance limits, replace the oil pressure sensor. - If resistance is within the tolerance range but function of oil pressure sensor is still questionable, measure the resistance over the entire field. PRESSURE 10.05 ill.12 RESISTANCE (OHM) Z001019/0_6_July 2008 Page ELECTRICAL SYSTEM - 91
Page 1 and 2:
STEYR MARINE ENGINES 4 CYLINDERS +
Page 3 and 4:
PREFACE STEYR MOTORS GmbH has devel
Page 5 and 6:
TABLE OF CONTENTS (MAIN ASSEMBLY GR
Page 7 and 8:
05 Cooling system 05.01 Cooler, hea
Page 9 and 10:
ToC SERVICE MANUAL MARINE ENGINES G
Page 11 and 12:
Page 13 and 14:
ToC SERVICE MANUAL MARINE ENGINES A
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
ToC SERVICE MANUAL MARINE ENGINES O
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
ToC SERVICE MANUAL MARINE ENGINES 0
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Page 155 and 156:
ToC SERVICE MANUAL MARINE ENGINES R
Page 157 and 158:
SERVICE MANUAL MARINE ENGINES 03 FU
Page 159 and 160:
Page 161 and 162:
Page 163 and 164:
Page 165 and 166:
Page 167 and 168:
Page 169 and 170:
Page 171 and 172:
Page 173 and 174:
Page 175 and 176:
Page 177 and 178:
Page 179 and 180:
Page 181 and 182:
Page 183 and 184:
Page 185 and 186:
Page 187 and 188:
Page 189 and 190:
Page 191 and 192:
Page 193 and 194:
SERVICE MANUAL MARINE ENGINES 03.14
Page 195 and 196:
Page 197 and 198:
Page 199 and 200:
Page 201 and 202:
SERVICE MANUAL MARINE ENGINES 05 CO
Page 203 and 204:
Page 205 and 206:
Page 207 and 208:
Page 209 and 210:
Page 211 and 212:
Page 213 and 214:
Page 215 and 216:
Page 217 and 218:
Page 219 and 220:
Page 221 and 222:
Page 223 and 224:
Page 225 and 226:
Page 227 and 228:
Page 229 and 230:
Page 231 and 232:
Page 233 and 234:
Page 235 and 236:
Page 237 and 238:
Page 239 and 240:
Page 241 and 242:
Page 243 and 244:
Page 245 and 246:
Page 247 and 248:
Page 249 and 250:
Page 251 and 252:
Page 253 and 254:
Page 255 and 256:
Page 257 and 258:
Page 259 and 260:
Page 261 and 262:
Page 263 and 264:
Page 265 and 266:
Page 267 and 268:
Page 269 and 270:
L J 6 5 4 2 3 1 23 ToC SERVICE MANU
Page 271 and 272:
Page 273 and 274:
Page 275 and 276: ToC SERVICE MANUAL MARINE ENGINES 0
Page 285 and 286: ToC SERVICE MANUAL MARINE ENGINES I
Page 287 and 288: ToC SERVICE MANUAL MARINE ENGINES E
Page 291 and 292: ToC SERVICE MANUAL MARINE ENGINES I
Page 299 and 300: °C °F 250 80 40 100 120 0 L MAIN
Page 301 and 302: °C °F 250 80 40 100 120 0 MAIN RP
Page 325: ToC SERVICE MANUAL MARINE ENGINES E
Page 331: ToC SERVICE MANUAL MARINE ENGINES E
show all

4 cylinders + 6 cylinders 4 cylinders + 6 cylinders - Steyr Motors

Create successful ePaper yourself

Delete template?

Save as template?