4 cylinders + 6 cylinders 4 cylinders + 6 cylinders - Steyr Motors

More documents

Recommendations

Info

ToC 04 EXHAUST SYSTEM SERVICE MANUAL MARINE ENGINES 04.01.02 Measurement of exhaust backpressure special tool No. VR00136/0 ill.1/pos.1 ill.1/pos.3 ill.1/pos.4 ill.1/pos.5 ill.1/pos.6 ill.1/pos.7 ill.1/pos.9 pressure gauge (0-1 bar) intermediate sealing ring pressure gauge connection pressure hose double union sealing ring screw-in adaptor 9 8 7 6 10 1 2 3 4 5 1 Disconnect plug for exhaust temperature switch (ill.2/ pos.5). 01.02 ill.1 2 Dismantle high-riser temperature sensor, connect plug to sensor again, and fix it temporary on the engine. 3 Mount double union (ill.1/pos.6) with sealing ring (ill.1/pos.7) instead of hi-riser temperature sensor. 9 7 6 1 3 4 4 For 6 cyl. engines only (with FORD ECU) Screw in double union (ill.1/6) with sealing ring (ill.1/ 7) into screw-in adaptor (ill.1/9) and mount screw-in adaptor instead of hi-riser temperature sensor. 5 Mount seal ring (ill.1/pos.3) with pressure gauge connection (ill.1/pos.4) onto pressure gauge (ill.1/ pos.1) Connect pressure gauge to one end of pressure hose (ill.1/pos.5). 6 Connect the other end of pressure hose (ill.1/pos.5) to double union (ill.1/pos.6). 01.02 ill.2 5 MEASUREMENT: Drive the boat under operating conditions (rated output at rated speed) and read off pressure on pressure gauge. RESULT: With an exhaust pressure below 100 mbar at rated output of engine, the exhaust system is dimentional correctly and represents the ideal status. (up to max. 200 mbar acceptable) With an exhaust pressure exceeding 200 mbar at rated output of engine, tuning of exhaust system is no more ideal. To avoid losses in efficiency, changes in the exhaust system should be made (pipe diameter, pipe lengths, muffler etc.) An exhaust pressure of 300 mbar at rated output of engine is no more acceptable. ATTENTION: Changes in the exhaust system (pipe diameter, pipe lengths, muffler etc.) absolutely required. Considerable influence on output, fuel consumption and life of engine. 7 Assembly is done in reverse order: Page EXHAUST SYSTEM - 4 Z001019/0_6_July 2008
ToC SERVICE MANUAL MARINE ENGINES 05 COOLING SYSTEM 05 COOLING SYSTEM Table of Contents Page 05.00 Functional description cooling circuit ............................................... 2 05.00.01 Raw water circuit (external cooling circuit) ............................................. 2 05.00.02 Closed coolant from cooling circuit (internal engine cooling circuit) ....... 4 05.00.03 Error detection cooling system ............................................................... 6 05.00.04 Check points for problems in cooling system ......................................... 9 05.00.05 Component check raw water system ................................................... 10 05.00.06 Component check engine cooling system................................................ 11 05.00.07 Drain the coolant system........................................................................ 13 05.00.08 Fill the cooling system ............................................................................. 15 05.01 Cooler, heat exchanger, expansion tank ............................................ 16 05.01.01 Coolant tank ........................................................................................... 16 05.01.02 Disassembly exhaust manifold - heat exchanger .................................. 17 05.01.03 Checks ................................................................................................... 21 05.01.04 Exchange heat exchanger element........................................................ 23 05.01.05 Assembly of exhaust manifold ............................................................... 24 05.01.06 Exchange tandem cooler ........................................................................ 26 05.01.07 Exchange additional oil cooler (only type 246) ........................................ 26 05.01.08 Exchange triple cooler............................................................................. 27 05.03 Pipes, thermostat ................................................................................. 27 05.03.01 Coolant pipes and hoses ....................................................................... 27 05.03.02 Exchange thermostat ............................................................................. 28 05.03.03 Exchange sacrificial anodes................................................................... 30 05.04 Coolant pump ........................................................................................ 31 05.04.01 Exchange coolant pump ........................................................................ 31 05.04.02 Install coolant pump ................................................................................ 32 05.06 Poly-V-Belt ............................................................................................. 33 05.06.01 Exchange Poly-V-belt .............................................................................. 33 05.07 V-belt ...................................................................................................... 34 05.07.01 Exchange V-belts .................................................................................... 34 05.07.02 Adjust V-belts .......................................................................................... 36 05.10 Raw water pump ................................................................................... 37 05.10.01 Exchange raw water pump...................................................................... 37 05.12 Checks .................................................................................................. 38 05.12.01 Check closed engine cooling system for air ............................................ 38 Z001019/0_6_July 2008 Page COOLING SYSTEM - 1
Page 1 and 2:
STEYR MARINE ENGINES 4 CYLINDERS +
Page 3 and 4:
PREFACE STEYR MOTORS GmbH has devel
Page 5 and 6:
TABLE OF CONTENTS (MAIN ASSEMBLY GR
Page 7 and 8:
05 Cooling system 05.01 Cooler, hea
Page 9 and 10:
ToC SERVICE MANUAL MARINE ENGINES G
Page 11 and 12:
Page 13 and 14:
ToC SERVICE MANUAL MARINE ENGINES A
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
ToC SERVICE MANUAL MARINE ENGINES O
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
ToC SERVICE MANUAL MARINE ENGINES 0
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
Page 147 and 148: ToC SERVICE MANUAL MARINE ENGINES 0
Page 155 and 156: ToC SERVICE MANUAL MARINE ENGINES R
Page 157 and 158: SERVICE MANUAL MARINE ENGINES 03 FU
Page 193 and 194: SERVICE MANUAL MARINE ENGINES 03.14
Page 197: ToC SERVICE MANUAL MARINE ENGINES 0
Page 201 and 202: SERVICE MANUAL MARINE ENGINES 05 CO
Page 249 and 250:
Page 251 and 252:
Page 253 and 254:
Page 255 and 256:
Page 257 and 258:
Page 259 and 260:
Page 261 and 262:
Page 263 and 264:
Page 265 and 266:
Page 267 and 268:
Page 269 and 270:
L J 6 5 4 2 3 1 23 ToC SERVICE MANU
Page 271 and 272:
Page 273 and 274:
Page 275 and 276:
Page 277 and 278:
Page 279 and 280:
Page 281 and 282:
Page 283 and 284:
Page 285 and 286:
ToC SERVICE MANUAL MARINE ENGINES I
Page 287 and 288:
ToC SERVICE MANUAL MARINE ENGINES E
Page 289 and 290:
Page 291 and 292:
ToC SERVICE MANUAL MARINE ENGINES I
Page 293 and 294:
Page 295 and 296:
Page 297 and 298:
Page 299 and 300:
°C °F 250 80 40 100 120 0 L MAIN
Page 301 and 302:
°C °F 250 80 40 100 120 0 MAIN RP
Page 303 and 304:
Page 305 and 306:
Page 307 and 308:
Page 309 and 310:
Page 311 and 312:
Page 313 and 314:
Page 315 and 316:
Page 317 and 318:
Page 319 and 320:
Page 321 and 322:
Page 323 and 324:
Page 325 and 326:
Page 327 and 328:
Page 329 and 330:
Page 331:
show all

4 cylinders + 6 cylinders 4 cylinders + 6 cylinders - Steyr Motors

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?