INFINITY ANALYZE User's Manual - Spectra Services

More documents

Recommendations

Info

Lumenera INFINITY ANALYZE User’s Manual Release 6.0.0 Unit and Square Unit abbreviation fields are available to specify how measurement units are to be presented. d. Finally, the relationship between microns and your preferred units of measure are specified in the field to the right of Linear Unit. If working in microns, then this field is left as 1. If working in any units other than microns, then the value entered into this field is the number of microns in one unit of the desired measurements. For example: enter 25400 in this field in working in inches, or 25,400 if working in thousands of an inch. Enter the length of the line, in microns, not counting magnification factor. Enter the nominal magnification. The magnification is used in printing only where the image appears magnified on paper. All measurements are done in microns and have nothing to do with magnifying factor. Ying’s comment: Add description Ying’s comment: Add description Push to close the dialog and commit the new settings of system micrometer. Page 110 Copyright © 2006-2011
Release 6.0.0 Lumenera INFINITY ANALYZE User’s Manual IMPORTANT Push to close the dialog and discard any change to system micrometer. Calibration should be performed on an image captured at Full Field of View to ensure that sub-sampling.is not enabled. 3.8.18 Measure Options The Measure Options dialog is used to specify how measurement annotations appear in the image. The first option on the dialog defines whether annotation graphics are generated or not. The number of Decimal Places is used to control the level of detail included with the measurement labels that appear. The Properties button is used to access an entire range of controls for Fonts and Graphic boxes used for the annotation labels. Note: For additional details on the Font and Graphic controls, refer to the descriptions provided under the section on Annotations. The remaining fields on the dialog allow for the specification of the Prefix characters that appear ahead of each measurement label that is generated. The operator can identify whether all, some, or none of the measurement types will produce a measurement in the captured image, and if a measurement is displayed, the actual prefix to use. Copyright © 2006-2011 Page 111
Page 1 and 2:
INFINITY ANALYZE User’s Manual
Page 3 and 4:
Release 6.0.0 Lumenera INFINITY ANA
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60: Release 6.0.0 Lumenera INFINITY ANA
Page 109: Release 6.0.0 Lumenera INFINITY ANA
show all

INFINITY ANALYZE User's Manual - Spectra Services

Create successful ePaper yourself

Delete template?

Save as template?