2013 4 29 ROSEMARY BEACH PROJECT MANUAL.pdf

DAG Architects Inc.
12041 ROSEMARY BEACH OWNERS CENTER
ROSEMARY BEACH,FL
1.6 QUALITY ASSURANCE
A. Installer Qualifications: An entity that employs installers and supervisors who are trained and
approved by manufacturer.
B. Composite panel manufacturer shall have a minimum of 15 years’ architectural experience in
the manufacture of this product and be located within the continental USA.
C. Fabrication and installation of composite panels shall be from a single source.
D. Fabricator shall be acceptable to composite panel manufacturer.
E. Fabricator and installer shall have a minimum 5 years’ experience in architectural metal panel
work similar in scope and size to this project.
F. Coordinate fabrication schedule with construction progress as directed by the contractor to
avoid delay of work.
G. Shop drawings shall show the preferred joint details providing a watertight and structurally
sound wall panel system that allows no uncontrolled water penetration, on the inside face of the
panel system as determined by ASTM E331.
H. Maximum deviation from vertical and horizontal alignment of erected panels: 6 mm (1/4") in 6
m (20') non-accumulative.
I. Panel fabricator and installer shall assume undivided responsibility for all components of the
exterior panel system, including but not limited to, attachment to sub-construction, panel-topanel
joinery, panel-to-dissimilar-material joinery and joint seal associated with the panel
system.
1.7 WARRANTY
A. Special Warranty: Manufacturer's standard form in which manufacturer agrees to repair or
replace components of metal composite material panel systems that fail in materials or
workmanship within specified warranty period.
1. Warranty Period: One year from date of Substantial Completion.
B. Special Warranty on Panel Finishes: Manufacturer's standard form in which manufacturer
agrees to repair finish or replace metal composite material panels that show evidence of
deterioration of factory-applied finishes within specified warranty period.
1. Finish Warranty Period: The aluminum composite material manufacturer shall warrant
for a period of 30 years against Max 5 fade based on ASTM D2244 and Max 8 chalk
based on ASTM D4212 and delamination of the paint from date of Substantial
Completion.
METAL COMPOSITE MATERIAL WALL PANELS 074213.23 - 2