2013 4 29 ROSEMARY BEACH PROJECT MANUAL.pdf

DAG Architects Inc.
12041 Rosemary Beach Owners Center
Rosemary Beach, Fl.
B. Accessories: Provide components for each through-penetration firestop system that
are needed to install fill materials and to comply with Part 1 "Performance
Requirements" Article. Use only components specified by through-penetration firestop
system manufacturer and approved by qualified testing and inspecting agency for
firestop systems indicated.
2.3 SLEEVES FOR RACEWAYS AND CABLES
A. Steel Pipe Sleeves: ASTM A 53/A 53M, Type E, Grade B, Schedule 40, galvanized
steel, plain ends.
B. Cast-Iron Pipe Sleeves: Cast or fabricated "wall pipe," equivalent to ductile-iron
pressure pipe, with plain ends and integral waterstop, unless otherwise indicated.
C. Coordinate sleeve selection and application with selection and application of
firestopping.
2.4 SLEEVE SEALS
A. Description: Modular sealing device, designed for field assembly, to fill annular space
between sleeve and raceway or cable.
1. Sealing Elements: EPDM interlocking links shaped to fit surface of cable or
conduit. Include type and number required for material and size of raceway or
cable.
2. Pressure Plates: Plastic. Include two for each sealing element.
3. Connecting Bolts and Nuts: Carbon steel with corrosion-resistant coating of
length required to secure pressure plates to sealing elements. Include one for
each sealing element.
PART 3 - EXECUTION
3.1 THROUGH-PENETRATION FIRESTOP SYSTEM INSTALLATION
A. General: Install through-penetration firestop systems to comply with Part 1
"Performance Requirements" Article and with firestop system manufacturer's written
installation instructions and published drawings for products and applications indicated.
B. Install forming/damming/backing materials and other accessories of types required to
support fill materials during their application and in the position needed to produce
cross-sectional shapes and depths required to achieve fire ratings indicated.
1. After installing fill materials and allowing them to fully cure, remove combustible
forming materials and other accessories not indicated as permanent components
of firestop systems.
C. Install fill materials for firestop systems by proven techniques to produce the following
results:
FIRESTOP SYSTEMS AND SLEEVES 26 05 23 - 3/6