2013 4 29 ROSEMARY BEACH PROJECT MANUAL.pdf

DAG Architects Inc.
12041 Rosemary Beach Owners Center
Rosemary Beach FL
PART 2 - PRODUCTS
2.1 GLASS PRODUCTS
A. Annealed Float Glass: ASTM C 1036, Type I (transparent flat glass), Quality-Q3; of class
indicated.
B. Heat-Treated Float Glass: ASTM C 1048; Type I (transparent flat glass); Quality-Q3; of class,
kind, and condition indicated.
1. Fabrication Process: By horizontal (roller-hearth) process with roll-wave distortion
parallel to bottom edge of glass as installed, unless otherwise indicated.
2. Provide Kind HS (heat-strengthened) float glass in place of annealed float glass where
needed to resist thermal stresses induced by differential shading of individual glass lites
and to comply with glass design requirements specified in Part 1 "Performance
Requirements" Article.
3. For uncoated glass, comply with requirements for Condition A.
4. For coated vision glass, comply with requirements for Condition C (other uncoated glass).
5. Provide Kind FT (fully tempered) float glass in place of annealed or Kind HS (heatstrengthened)
float glass where safety glass is indicated.
C. Laminated Glass: ASTM C 1172, and complying with other requirements specified and with the
following:
1. Interlayer: Manufacturer’s standard of required thickness with a proven record of no
tendency to bubble, discolor, or lose physical and mechanical properties after laminating
glass lites and installation.
D. Tempered Glass: ASTM C 1048, Kind FT (Fully tempered), Type I (Transparent flat glass)
Quality-Q-1, Class I (clear).
1. Safety glazing locations are defined by the Florida Building Code for specific required
locations.
2.2 FIRE-RATED GLAZING PRODUCTS
A. Fire-Protection Rating: 20 minute to 90 minute fire-rating, as indicated for the assembly in
which glazing material is installed, and permanently labeled by a testing and inspecting agency
acceptable to authorities having jurisdiction.
B. Supplier: FireLite NT as supplied by Technical Glass Products, Kirkland, Washington ph: 1-
800-426-0279, fax 1-800-451-9857, email: sales@fireglass.com, web site: www.fireglass.com.
1. Architect approved equal.
C. Properties:
1. Thickness: 3/16-inch.
2. Film: 3M Scotchshield Ultra Film or as required per manufacturer.
3. Fire Rating:
a. 20-minutes.
b. 45-minutes.
c. 90-minutes.
4. Surface Finish: Standard (unpolished).
D. Labeling: Permanently label each piece of FireLite NT with the FireLite Logo and fire rating in
sizes up to 3,325 sq. inch, and with the FireLite label only for sizes that exceed the listing (as
approved by the local authority having jurisdiction).
E. Fire Rating: Fire rating listed and labeled by UL for fire rating scheduled at opening on
drawings, when tested in accordance with ASTM E2074, ASTM E2010, NFPA 252, NFPA 257,
UL 9, UL 10B, UL 10C.
F. Glazing compound for Fire-Rated Glazing Materials:
1. Glazing Tape: Closed call polyvinyl chloride (PVC) foam, coiled on release paper over
adhesive on two sides, maximum water absorption by volume of 2 percent. Glass panels
that exceed 1,393 sq. inches for 90-minute ratings must be glazed with fire-rated glazing
tape supplied by manufacturer.
GLAZING 08 80 00 - 3