2013 4 29 ROSEMARY BEACH PROJECT MANUAL.pdf

DAG Architects Inc.
12041 Rosemary Beach Owners Center
Rosemary Beach Fl.
SECTION 23 05 29 - SUPPORTS, ANCHORS, AND SEALS
1 GENERAL
1.1 Drawings and general provisions of Contract, including General Supplementary Conditions and
Division-1 Specification sections, apply to work of this section.
1.2 This section is a Division-23 Basic Materials and Methods section, and is a part of each
Division-23 section making reference to or requiring supports, anchors, and seals specified
herein.
1.3 Extent of supports, anchors, and seals required by this section is indicated on drawings and/or
specified in other Division-23 sections.
1.4 Code Compliance: Comply with applicable codes pertaining to product materials and
installation of supports, anchors, and seals.
1.5 MSS Standard Compliance:
1.5.1 Provide pipe hangers and supports of which materials, design, and manufacture comply with
ANSI/MSS SP-58.
1.5.2 Select and apply pipe hangers and supports, complying with MSS SP-69.
1.5.3 Fabricate and install pipe hangers and supports, complying with MSS SP-89.
1.5.4 Terminology used in this section is defined in MSS SP-90.
2 PRODUCTS
2.1 Acceptable Manufacturers: Subject to compliance with requirements, provide supports and
hangers by Grinnel, Michigan Hanger Company, B-Line Systems, or approved equal.
2.2 Horizontal-Piping Hangers and Supports: Except as otherwise indicated, provide factoryfabricated
horizontal-piping hangers and supports complying with ANSI/MSS SP-58, of one of
the following MSS types listed, selected by Installer to suit horizontal-piping systems, in
accordance with MSS SP-69 and manufacturer's published product information. Use only one
type by one manufacturer for each piping service. Select size of hangers and supports to
exactly fit pipe size for bare piping, and to exactly fit around piping insulation with saddle or
shield for insulated piping. Provide copper-plated hangers and supports for copper-piping
systems.
2.2.1 Adjustable Steel Clevises: MSS Type 1.
2.2.2 Steel Double Bolt Pipe Clamps: MSS Type 3.
2.2.3 Adjustable Steel Band Hangers: MSS Type 7.
2.2.4 Steel Pipe Clamps: MSS Type 4.
2.2.5 Pipe Stanchion Saddles: MSS Type 37, including steel pipe base support and cast-iron floor
flange.
2.2.6 Single Pipe Rolls: MSS Type 41.
2.2.7 Adjustable Roller Hanger: MSS Type 43.
SUPPORTS, ANCHORS, AND SEALS 23 05 29 -1/4