en/ACS800-04/U4 Hardware Manuals - VAE ProSys sro

107Cable entriesBrake resistor, input and motor cable (per phase) terminal sizes and tighteningtorques are given below.Frame U1, V1, W1, U2, V2, W2, R+, R- Earthing PEsize Maximum wire size Tightening torque Maximum wire size Tightening torqueAWG lbf ft AWG lbf ftR2 up to 6 * 0.9…1.1 up to 8 1.1R3 up to 6 * 0.9...1.1 up to 8 1.1R4 up to 4 1.5…3.0 up to 5 2.2R5 10...2/0 11.1 10...2/0 11.1R6 3/0...2×4/0 ** 14.8...29.5 4/0 5.9* 6 AWG rigid solid cable, 8 AWG flexible stranded cable** with cable lugs 6...2/0 AWG, tightening torque 14.8...29.5 lbf ft. Cable lugs are not included in thedelivery. See page 64.Dimensions, weights and noiseFrame size Height Width Depth* Weight Noisein. in. in. lb dBR2 14.57 6.5 7.6...8.9 18 62R3 16.54 6.81 9.11...10.43 29 62R4 19.29 9.45 9.93...10.69 53 62R5 23.70 10.43 10.85...11.11 71 65R6 27.56 11.81 15.71 141 65* Depth depends on the options included in the drive.Input power connectionVoltage (U 1 )Rated conditional shortcircuitcurrent (IEC 60439-1)Short-circuit currentprotection (UL 508 CCSA C22.2 No. 14-05)FrequencyImbalanceFundamental power factor(cos phi 1 )208/220/230/240 V AC 3-phase ±10% for 230 V AC units380/400/415 V AC 3-phase ±10% for 400 V AC units380/400/415/440/460/480/500 V AC 3-phase ±10% for 500 V AC units525/550/575/600/660/690 V AC 3-phase ±10% for 690 V AC units65 kA when protected by fuses given in the IEC data fuse tables.US and Canada: The drive is suitable for use on a circuit capable of delivering not morethan 100 kA rms symmetrical amperes at the drive nominal voltage when protected byfuses given in the NEMA data fuse table.48 to 63 Hz, maximum rate of change 17%/sMax. ±3% of nominal phase to phase input voltage0.98 (at nominal load)Technical data