Installation and User's Guide - Services and Support

IBM ConfidentialNote: If you need to make corrections after installing a service:a. Issue the following command to remove the service:dsmcutil remove /name:"Data Protection for Exchange Scheduler"b. Issue the command in Step 4 again to install a new service.Note: If you are setting up the scheduler service for an Exchange Serverrunning in a cluster environment, repeat Step 1 through Step 4 on thesecondary node of the cluster. IMPORTANT! The name of the schedulerservice created by the dsmc util command in Step 4 and the cluster servicemust have the same logon authority.5. The Tivoli Storage Manager scheduler is now installed but has not started. Tostart the scheduler IN A NON-CLUSTER ENVIRONMENT, issue the followingcommand in the Windows command prompt window:net start "Data Protection for Exchange Scheduler"This output is displayed:The Data Protection for Exchange Scheduler service is starting.The Data Protection for Exchange Scheduler service was startedsuccessfully.Note that because /autostart:yes is specified, the Tivoli Storage Managerscheduler automatically starts each time the Windows system is rebooted.Note:IMPORTANT!v If you are creating the scheduler service in a non-cluster environment,proceed directly to Step 13.v If you are creating the scheduler service in a cluster environment, performStep 6 through Step 13.The newly created scheduler service is tied to a cluster group. This allows theTivoli Storage Manager scheduler to correctly fail over between the nodes andalso manage automatic password changes.6. Start the Cluster Administrator.7. Select the Exchange Server Cluster Group and create a new Resource torepresent the Data Protection for Exchange scheduler (File–>New–>Resource).Make sure the following parameters are specified:Resource TypeSpecify Generic Service.Group Specify the Exchange Virtual Server.Possible OwnersMake sure both node machines are listed. Add them if they are notlisted.Resource DependenciesMake sure the Exchange Virtual server and the shared drives wherethe options file is located are listed.Generic Service–>Service NameSpecify the exact name of the scheduler service.For example:Name: Data Protection for Exchange SchedulerDescription: Data Protection for Exchange SchedulerResource Type: Generic ServiceGroup: MARSEXC1Chapter 6. Using the Tivoli Storage Manager scheduler 119