Daelim S4 50cc Service Manual - Mojo

CHARGING SYSTEMSCREWBATTERYBATTERY● Loosen the screws and remove the battery cover.● Disconnect the negative battery cable first, andthen disconnect the positive cable.● Remove the battery.● Install in the reverse order of removal.BATTERY COVERBATTERY(OPEN-CIRCUIT VOLTAGE)INSPECTION● Remove the battery cover.● Measure the voltage between the battery terminals.FULL CHARGED : 12.6~13.0 VINSUFFICIENTLY CHARGED : UNDER 12.3 VNOTE•Use a voltmeter that will accurately indicate 0.1Vdifference.•When measuring the battery voltage after charging,leave it for at least 30 minutes, or the accurateresults cannot be obtained because the batteryvoltage fluctuates just after charging.BATTERY CHARGING● Remove the battery.● Connect the charging cable and battery terminal.● Connect the charging cable and battery terminal.NOTE•Be sure to the battery charging is not allow toexceed the specified charging time and current.•To avoid the rapid charging could be possible toreduce the battery life and cause of damage.AMMETERBATTERY TERMINALCHARGING SYSTEMINSPECTIONLEAK TEST● Turn off the ignition switch, and disconnect theground cable from the battery.● Connect an ampere meter between negative terminal and ground cable.● With the ignition switch off, measure the leakagecurrent.LEAK CURRENT : 0.1A(BELOW)EARTH CABLE