PXA3xx Boot ROM Reference Manual - Marvell

Image ID: 0x4F424D49Next Image ID: 0x4F534c4FFlash Entry Address: 0x20000Load Address: 0x5c013000Image Size To CRC in bytes: 0Image Filename: MHLV_wince_NTOBM.binImage ID: 0x4F534c4FNext Image ID: 0xFFFFFFFFFlash Entry Address: 0x40000Load Address: 0x83C00000Image Size To CRC in bytes: 0Image Filename: eboot.nb0Reserved Data:0x4F505448 // Package structure identifier0x00000002 // number of packages, note must include termination package0x4750494f // GPIO package0x00000024 // package size0x00000003 // number of pairs0x40e104d0 // MFPR reg address0x00000840 // data0x40e00014 // GPDR2 reg address0x00001000 // set GPIO 76 as output0x40e00020 // GPSR2 reg address0x00001000 // set GPIO 76 high0x5465726D // Termination package0x000000085.1.3 Requirements for the Wireless Trusted Module Save StateThe Marvell ® Wireless Trusted Module (Marvell ® WTM) save state is implemented with a slot-basedmechanism to provide wear leveling on the flash device. Figure 7 shows the layout for the Marvell ®WTM save state implementation. Two blocks of flash are currently allocated for the Marvell ® WTMsave state: a primary Marvell ® WTM save state, and a backup Marvell ® WTM save state. Thelocation of the Marvell ® WTM state files is part of the information located in the trusted imagemodule and covered by the digital signature to prevent attacks on the system.12345678910111213141516171819202122232425262728293031323334353637383940414243444546474849505152535455565758Copyright © 2010 Marvell PUBLIC RELEASE Doc. No. MV-S301208-00 Rev. -Page 37