G4 Multi Channel Weighing Instrument. PM/DT/HE Technical Manual

Technical ManualScale X: Gross weightThis register holds the gross weight for a scale. The weight should not be read alonebecause the status and error codes are stored in other registers. The weight is onlyvalid when the register ‘Scale X:Error code’ equals 00.Scale X: Net weightThis register holds the net weight for a scale. The weight should not be read alonebecause the status and error codes are stored in other registers. The weight is onlyvalid when the register ‘Scale X:Error code’ equals 00.Scale X: Flow rateThis register holds the flow rate for a scale. The flow rate should not be read alonebecause the status and error codes are stored in other registers. The flow rate isonly valid when the register ‘Scale X:Error code’ equals 00.Scale X: Input signal (mV/V)This register holds the current input signal in mV/V for a scale. This register could beused for fault finding in the system.Analog output value 1, 2, 3, 4These registers holds the values sent to the analog outputs. The registers can be usedfor fault finding in the system.Note: The value is rounded to 3 decimals.Status of inputs 11-18, 21-28Bits set to 1 in this register have the following meaning:Bit no Function Bit no Function0 Digital input 11 activated. 8 Digital input 21 activated.1 Digital input 12 activated. 9 Digital input 22 activated.2 Digital input 13 activated. 10 Digital input 23 activated.3 Digital input 14 activated. 11 Digital input 24 activated.4 Digital input 15 activated. 12 Digital input 25 activated.5 Digital input 16 activated. 13 Digital input 26 activated.6 Digital input 17 activated. 14 Digital input 27 activated.7 Digital input 18 activated. 15 Digital input 28 activated.Note: If this register (bits) is read as float value,see description of Data representation.6-12