G4 Multi Channel Weighing Instrument. PM/DT/HE Technical Manual

Technical ManualRange/Alternatives1:Zero TrackingOffOnOn+AutoZero1:Zero-Track.RateRange:0 to 1500Unit: /min1:Tare Corr.ModeAutoPresetAuto+Preset1:Flow CalculationOnOffExplanation andresult of alternatives.With this parameter automatic zero-tracking can beselected, or a combination of automatic zero-trackingand automatic zero setting.Off: No zero tracking.On: Zero tracking active.On+AutoZero: Zero tracking and auto zeroing active.Maximum weight change speed for zero-trackingto be performed.‘Zero-track.rate’ must be less than (30 * Resolution).Unit for the Zero-track rate is: Measurem. unit/min,expressed as ‘ /min’ to save space.Note: this parameter is only shown if parameter‘1: Zero tracking’ is set to ‘On’ or ‘On+AutoZero’.The tare value can be calculated in three different ways:Net weight = Gross weight – Tare valueAuto: Auto tare value is used.Preset: Tare value is entered throughthe serial communication or keypad.Auto+preset: Tare value is the sum ofthe preset tare value and auto tare value.Used to turn on and off the flow rate calculations.On: Flow rate calculations are performed.Off: Flow rate calculations are not performed.1:Flow Rate Resolution0.0010.0020.0050.010.020.050.10.20.5125102050Defines the decimal point position and resolution formatfor the flow rate value.All set-up parameters using the flow rate unit will bewritten with the decimal point position selected inthis menu.If the last digits of the flow rate value are not stable,a more coarse resolution can be selected to geta stable reading.Note: this parameter is only shown if parameter ‘1:Flowcalculation’ is set to ‘On’.3-18