G4 Multi Channel Weighing Instrument. PM/DT/HE Technical Manual

Technical ManualRange/AlternativesExplanation andresult of alternatives.Menus ‘Inputs Slot 1’ - ‘Inputs Slot 6’NOTE: There are six possible sub menus, one for each slot. In each slot sub menuthere are up to 8 possible inputs named 11 to 18 for slot 1, 21 to 28 for slot 2 and soon. Each input has the parameters described below. Note that input numbering belowonly show inputs belonging to slot 1. The ‘Inputs Slot X’ is only shown if there is amodule with inputs selected for slot X. The number of displayed inputs is the number ofinputs of the specific module selected in menu ‘Hardware Configuration’.Input 11 Use (- Input 18 Use)Not in useDefines the use of the internal digital inputs in the instrument.TareNot in use: The input is not used.Gross/NetTare: Input used for taring command.GrossGross/Net: Input used for gross/net toggling.NetGross: Input used to switch to gross mode.ZeroNet: Input used to switch to net mode.Flow/WeightFlow RateZero: Input used for zero command.WeightFlow/Weight: Input used for flow rate/weight toggling.Flow Rate: Input used to switch to flow rate mode.< Not in use >Weight: Input used to switch to weight mode.Input 11 Scale (- Input 18 Scale)123456781: Scale number 1 uses the input.2: Scale number 2 uses the input.….8: Scale number 8 uses the input.Note: this parameter is not shown if parameter‘Input 11 Source’ is ‘Not in use’.3-34