G4 Multi Channel Weighing Instrument. PM/DT/HE Technical Manual

Technical ManualWeight errorsThe indication is either temporary or stays on until the cause is cured.ErrorcodeExplanation000 No error.The instrument is in ‘normal state’ and no error is detected.003 Instrument not in normal state.Weight is not valid.004 OverloadOverload means that the weight exceeds the highest allowed limit that isspecified in the set-up parameters ‘Overload check’ and ‘Overload limit’.005 Over rangeOverrange means that the input signal from the transducer exceedsthe operating range.006 UnderloadUnderload means that the weight is below the lowest allowed limit that isspecified in the set-up parameters ‘Overload check’ and ‘Overload limit’.007 Under rangeUnderrange means that the input signal from the transducer is belowthe operation range.010 Excitation short-circuitEither a short-circuit in the excitation circuit or too many transducersconnected. (A fault in a transducer or inside the instrument is also possible.)Check transducer connections. See section '2 Installation'.011 Sense voltage errorThe sense voltage is out of range. Check transducer connections.See section '2 Installation'.012 Transducer signal errorThe input signal is out of range, for example due to a faulty or missing transducerconnection. (A fault in a transducer or inside the instrument is also possible.)Check transducer connections. See section '2 Installation'.014 Invalid input signalInvalid input signal is reported while the instrument is waiting for sufficientconversion data to calculate a valid weight value. This indication is reportedduring power-up and after changing the HSWF / WFIN Update Rate settingssince input value might be momentarily unreliable.020,191Too many digitsThe actual weight value with the configured number of decimalsis exceeding 6 digits.7-2