G4 Multi Channel Weighing Instrument. PM/DT/HE Technical Manual

Technical ManualRange/AlternativesMenu ‘Serial Com’Modbus AddressRange: 1 to 247Explanation andresult of alternatives.Defines the instrument Modbus address.COM1:ModeNot in useModbus SlaveCOM1:Baudrate3006001200240048009600192003840057600115200Defines use of serial port Com 1.Not in use: The port is not used.Modbus Slave: The port is used for control unitcommunication.Defines the baudrate for the serial communication.The parameter must be set to the baudrate ofthe external equipment.Note: This parameter is not shown if ‘Not in use’ is selectedin ‘COM1:Mode’.COM1:Data Format7-none-27-even-17-even-27-odd-17-odd-28-none-18-none-28-even-18-odd-1< 8-none-1 >COM1:Min Reply TimeRange: 0 to 1000Unit: msDefines the bit configuration for the serialcommunication.The parameter must be set to the same configuration asfor the external equipment.Note: This parameter is not shown if ‘Not in use’ isselected in ‘COM1:Mode’.Adds a delay before the response to a command is sent.Used if the instrument sends its response to fast for themaster.Note: This parameter is not shown if ‘Not in use’ isselected in ‘COM1:Mode’.3-26