G4 Multi Channel Weighing Instrument. PM/DT/HE Technical Manual

G4 Multi Channel Weighing Instrument(Continued)ErrorcodeExplanation113 Outside zero setting limits.Adjustment of the zero setting during operation is only possible ifthe accumulated correction required is within -1% to +3% ofthe capacity set-up.Consequently, if you transmit a zero setting command while the requiredadjustment is outside allowed range you will receive this error code.114 Setpoint(s) not in use.Activation/Deactivation of setpoint(s) cannot be done, as at least one ofthe setpoint sources is/are set to ‘not in use’.116 Net mode not allowed.Net weight cannot be shown when the tare value equals 0.117 Flow display not allowed.Flow rate is not enabled for the actual scale.118 Zero setting not allowed.Zero setting is not allowed when the calibration menu is displayedfor the actual scale.240 Fieldbus command error.Command error response on fieldbus connection.Indicates that the command sent to the G4 instrument via the fieldbusconnection could not be executed.249 Internal TimeoutA timeout occurred when the program tried to access some internalresources. If this error occurs when a command is sent to the instrument,try the command again.Restart the instrument or contact the supplier if the error persists.7-5