G4 Multi Channel Weighing Instrument. PM/DT/HE Technical Manual

G4 Multi Channel Weighing InstrumentRange/Alternatives1:Flow Rate UnitUnit/sUnit/minUnit/hUnit*1000/mUnit*1000/hExplanation andresult of alternatives.Defines the engineering unit that should be used forthe flow rate value and for related set-up parameters.Unit/s: Measurement unit per second.Unit/min: Measurement unit per minute.Unit/h: Measurement unit per hour.Unit*1000/m: Measurement unit * 1000 per minute.Unit*1000/h: Measurement unit * 1000 per hour.If the flow rate unit exceeds 4 characters then it will berepresented as ”/s”, ”/min”,”/h”, ”*/mi” or ”*/h” inthe set-up menus.In the case of ”Unit*1000/m” or ”Unit*1000/h” thensome flow rate units will be preceded by a ”k” andsome will be converted, for example ”kg” to ”t”.Note: this parameter is only shown if parameter ‘1:Flowcalculation’ is set to ‘On’.1:Auto Derivation TimeOffOnThe derivation time can be entered manually orcalculated automatically by the instrument.Off: Manual entering of derivation time.On: Automatic calculation of derivation time.Note: this parameter is only shown if parameter ‘1:Flowcalculation’ is set to ‘On’.1:Derivation TimeRange:0.00 – 3600.00Unit: sThe flow rate is the weight change over the latestelapsed ”Derivation time” divided by this time.At calibration the derivation time is always adjustedby the instrument to the nearest possible value(depending on the filter time).Note: this parameter is only shown if parameter ‘1:Flowcalculation’ is set to ‘On’.Note: This parameter is read only if‘1:Auto derivation time’ is set to ‘On’.3-19