G4 Multi Channel Weighing Instrument. PM/DT/HE Technical Manual

Technical ManualRange/AlternativesData Block 1 TypeNot In UseGross WeightNet WeightDisp. WeightFlow RateInput SignalLevel StatusSetpoint StatusInput StatusOutput StatusInp./Outp StatusLev./Setp StatusAOUT1-4 ValueAOUT1-2 ValueAOUT3-4 Value< Not In Use >Explanation andresult of alternatives.Sets the data source for Data Block 1.Not In Use: The memory area corresponding to this data blockis not updated.Gross Weight: The gross weight for the selected scale istransmitted in this Data Block. Floating point or Integer format.Net Weight: The net weight for the selected scale istransmitted in this Data Block. Floating point or Integer format.Disp. Weight: The displayed weight (gross or net) for theselected scale is transmitted in this Data Block. Floating pointor Integer format.Flow Rate: The Flow Rate for the selected scale is transmittedin this Data Block. Floating point or Integer format.Input Signal: The input signal from the transducer (the mV/Vsignal) for the selected scale is transmitted in this Data Block.Floating point or Integer format.Level Status: The status of all 32 levels in the instrument istransmitted in this Data Block. Floating-point format.Setpoint Status: The status of all 16 setpoints in theinstrument is transmitted in this Data Block. Floating-pointformat.Input Status: The status of all inputs in the instrument istransmitted in this Data Block. Floating-point format.Output Status: The status of all outputs in the instrument istransmitted in this Data Block. Floating-point format.Inp./Outp Status: The status of all inputs and all outputs in theinstrument is transmitted in this Data Block. Integer format.Lev./Setp Status: The status of all 32 levels and the status ofall 16 setpoints in the instrument are transmitted in this DataBlock. Integer format.AOUT1-4 Value: The values of analog outputs 1 to 4 aretransmitted in this Data Block. Floating-point format.AOUT1-2 Value: The values of analog outputs 1 and 2 aretransmitted in this Data Block. Integer format.AOUT3-4 Value: The values of analog outputs 3 and 4 aretransmitted in this Data Block. Integer format.Note: This parameter is only shown if parameter‘No Of Data Blocks‘ is set to 1 or greater.Data Block 1 FormatFloating Point Sets the Data Block 1 Format.IntegerFloating Point: The Data Block data format is floating point.< Floating Point >Integer: The Data Block format is integer.Note: This parameter is only shown if parameter‘No Of Data Blocks‘ is set to 1 or greater and parameter ‘DataBlock 1 Type‘ is set to ‘Gross Weight’, ‘Net Weight’, ‘Disp.Weight’, ‘Flow Rate’ or ‘Input Signal’.3-30