G4 Multi Channel Weighing Instrument. PM/DT/HE Technical Manual

Technical ManualRange/AlternativesExplanation andresult of alternatives.Menus ‘Level 1’ – ‘Level 32’NOTE: There are 32 levels each with the following four parameters described below.Level 1 Source ( - Level 32 Source)Not in useNet WeightGross WeightDisplay WeightFlow RateAbs. Net WeightAbs.Gross WeightAbs.Disp. WeightAbs. Flow Rate< Not in use >Defines the signal to be supervised by the level.Not in use: The level is not used, any outputs set towork with this level will be off.Net weight: The level operates on the net weight.Gross weight: The level operates on the gross weightDisplay weight: The level operates on gross weight ornet weight, even if the flow rate is displayed.Flow rate: The level operates on the flow rate.Abs.: Stands for Absolute,the level operates on the absolute value of net weight,gross weight, displayed weight, or flow rate.Level 1 Scale ( - Level 32 Scale)1Defines which scale that will be supervised by the level.21: The level is supervising scale number 1.32: The level is supervising scale number 2.45….68: The level is supervising scale number 8.78Note: This parameter is only shown if ‘Level 1 Source’ isnot set to ‘Not in use’.Level 1 Output ( - Level 32 Output)Active AboveActive Below< Active above >This parameter defines the conditions for control of apossible used output.Active above: The used output is activated asthe supervised signal level is above the set level.Active below: The used output is activated asthe supervised signal level is below the set level.Note: This parameter is only shown if ‘Level 1 Source’ isnot set to ‘Not in use’.Level 1 Hystereses ( - Level 32 Hystereses)Range:+/-999999Unit:Measurem. unitor flow unit.< 0.2 >Defines the hystereses range for the level.Positive value gives a hystereses range above theswitch level, negative value gives a range below theswitch level.Note: This parameter is only shown if ‘Level 1 Source’ isnot set to ‘Not in use’.3-32