G4 Multi Channel Weighing Instrument. PM/DT/HE Technical Manual

G4 Multi Channel Weighing InstrumentRange/AlternativesExplanation andresult of alternatives.Menu ‘Analog Outputs’NOTE: There are 4 possible analog outputs each with the 8 parameters describedbelow. If the selected analog output module is AOUT4 there will be parameters for fouranalog outputs displayed, if the AOUT1 is selected only the parameters for the firstanalog output (shown below) will be shown. If no AOUT module at all is selected themenu ‘Analog Outputs’ will not be shown.AOUT 1 Source (- AOUT 4 Source)Not in useGross WeightNet WeightDisp. WeightFlow Rate< Not in use >AOUT 1 Scale (- AOUT 4 Scale)12345678< 1 >Defines the value to represent on analog output 1.Not in use: The analog output is not used.Gross Weight: The output represents gross weight.Net Weight: The output represents net weight.Disp. Weight: The output represents gross or netweight, even if flow rate is displayed.Flow Rate: The output represents flow rate.1: Scale number 1 uses this analog output.2: Scale number 2 uses this analog output.….8: Scale number 8 uses this analog output.Note: this parameter is not shown if parameter‘AOUT 1 Source’ is ‘Not in use’.AOUT 1 Output Type (- AOUT 4 Output Type)+/– 20 mA–12 – 20 mA0-20 mA4-20 mA+/–10 V0-10 VDefines the type of signal, used to representthe weight/flow rate value at this Analog output.+/–20mA, –12 - 20mA: bipolar current output.0-20mA, 4-20mA: monopolar current output.+/–10V: bipolar voltage output.0-10V: monopolar voltage output.Note: this parameter is not shown if parameter‘AOUT 1 Source’ is ‘Not in use’.Note that in most cases some over range is available.+/-20 mA and -12 – 20 mA ranges are limitedat -22 and +22 mA.4 -20 mA range is limited at +4 and +22 mA.0 -20 mA is limited at 0 and +22 mA.+/-10 V is limited at -11 and +11V.0–10 V is limited at 0 and +11V.3-37