G4 Multi Channel Weighing Instrument. PM/DT/HE Technical Manual

Technical ManualCommand registerAs this register is read, the answer will always contain only zeros.There are a number of actions that can be activated in the instrument. The value of thisregister (when different from zero) will activate one of these actions, as described inbelow.When an action can not be performed for some reason (wrong state etc.) an exceptionis given as reply. When an exception with code 03 or 07 is received the command errorregister could be read to get a better error explanation.Cmd Action activated ininstrument0 No actionDescription1 Start operation When the instrument is in ‘Wait for start state’,this command can be used to start up theinstrument.2 Enter Remote operation This command disables the keys on theinstrument. This means that an externalcomputer is controlling the instrument or theinstrument is controlled using digital inputs.3 Exit Remote operation This command enables the keys and leavesthe remote operation.10 Scale 1: Auto tare11 Scale 1: Set to zero Used to set the gross weight to zero.12 Scale 1: Select gross mode13 Scale 1: Select net mode14 Scale 1: Weight display Show weight on the display.15 Scale 1: Flow rate display Show flow rate on the display.20 Scale 2: Auto tare21 Scale 2: Set to zero Used to set the gross weight to zero.22 Scale 2: Select gross mode23 Scale 2: Select net mode24 Scale 2: Weight display Show weight on the display.25 Scale 2: Flow rate display Show flow rate on the display.30 Scale 3: Auto tare31 Scale 3: Set to zero Used to set the gross weight to zero.32 Scale 3: Select gross mode6-20