G4 Multi Channel Weighing Instrument. PM/DT/HE Technical Manual

Technical ManualDeviceNetModule typeConnectorBaudrateAddressFieldbus dataMountingSettingsBus Supply VoltageDeviceNet fieldbus adaptor5 pin male connector.125, 250, 500 kbps or Auto. Set by parameter.0 – 63, set by parameter16 bytes from fieldbus to instrument.32 – 244 bytes from instrument to fieldbus (may be limitedby the master).See chapter ‘6 Communication’ section‘Fieldbus communication interface’ for details on fieldbusdata mapping.The fieldbus adaptor is mounted through the front ofthe CPU module with LED’s and connector accessiblethrough the CPU front panel.Remove the plastic cover from the fieldbus slot in the CPUmodule front panel. Insert the adaptor very carefully andmake absolutely sure that the adaptor slides correctly intothe guides in the connector on the CPU PCB. Tightenthe two fastening screws at the adaptor front and checkthat the two securing hooks locks into the CPU PCB.All fieldbus settings are done with setup parameters inthe instrument. No settings are done on the module itself.According to the DeviceNet (Node) Specification:nominal 24 VDC, range 11 – 25 VDC.1-10