G4 Multi Channel Weighing Instrument. PM/DT/HE Technical Manual

Technical ManualRange/AlternativesExplanation andresult of alternatives.AOUT 1 Range Low (- AOUT 4 Range Low)Range:+/–999999Unit:Measurem. unitor flow unitDefines the weight/flow rate value that shouldgive the lowest output (0 V / 0 mA / 4 mA) at thisAnalog output.Note: this parameter is not shown if parameter‘AOUT 1 Source’ is ‘Not in use’.AOUT 1 Range High (- AOUT 4 Range High)Range:+/–999999Unit:Measurem. unitor flow unitDefines the weight/flow rate value that shouldgive the highest output (10 V / 20 mA) at thisAnalog output.Note: this parameter is not shown if parameter‘AOUT 1 Source’ is ‘Not in use’.AOUT 1 Bandwidth (- AOUT 4 Bandwidth)1.6 HzSets the analog output bandwidth.3 HzNote: this parameter is not shown if parameter6 Hz‘AOUT 1 Source’ is ‘Not in use’.12 Hz25 Hz50 Hz100 HzAOUT 1 Low Adjust (- AOUT 4 Low Adjust)Range:+/-2.000Unit: %Gives a possibility to adjust the offset of the analogoutput. This allows for the reading of an externalinstrument connected to the analog output to be finetuned.Full adjustment range corresponds toapproximately +/-2% of maximum analog output.The parameter value will be set to zero each time‘AOUT 1 Output Type’ is changed.Note: this parameter is not shown if parameter‘AOUT 1 Source’ is ‘Not in use’.AOUT 1 High Adjust (- AOUT 4 High Adjust)Range:+/-2.000Unit: %Gives a possibility to adjust the gain of the analog outputsignal. This allows for the reading of an externalinstrument connected to the analog output to be finetuned.Full adjustment range corresponds toapproximately +±/-2% of maximum analog output.The parameter value will be set to zero each time‘AOUT 1 Output Type’ is changed.Note: this parameter is not shown if parameter‘AOUT 1 Source’ is ‘Not in use’.3-38