G4 Multi Channel Weighing Instrument. PM/DT/HE Technical Manual

G4 Multi Channel Weighing InstrumentRange/AlternativesExplanation andresult of alternatives.COM1:Floating Point FormatModicon FloatFloat< Modicon Float >Sets how the Modbus slave should handle floating pointvalues.Modicon Float: Modicon floating point format.Float: IEEE 32 bit floating point formatSee chapter 6 Communication for details on floatingpoint values.Note: This parameter is not shown if ‘Not in use’ isselected in ‘COM1:Mode’.COM2:ModeNot in useModbus SlaveCOM2:Baudrate3006001200240048009600192003840057600115200Defines the use for serial port Com 2.Not in use: The serial port is not used.Modbus Slave: The serial port is used forcommunication with a control unit.Defines the baudrate for the serial communication.The parameter must be set to the baudrate ofthe external equipment.Note: This parameter is not shown if ‘Not in use’ isselected in ‘COM2:Mode’.COM2:Data Format7-none-27-even-17-even-27-odd-17-odd-28-none-18-none-28-even-18-odd-1< 8-none-1 >COM2:Min Reply TimeRange: 0 to 1000Unit: msDefines the bit configuration for the serialcommunication.The parameter must be set to the same configurationas for the external equipment.Note: This parameter is not shown if ‘Not in use’ isselected in ‘COM2:Mode’.Adds a delay before the response to a Modbuscommand is sent. Used if the instrument sends itsresponse to fast for the Modbus master.Note: This parameter is not shown if ‘Not in use’ isselected in ‘COM2:Mode’.3-27