Network Force/Torque Sensor System

Net F/T Installation and Operation Manual
Document: 9620-05-net ft-11
Step 11: On the left side of the page are menu buttons that link to various pages. Click on the
Communications button.
Figure 3.14—The Net F/T’s Communications Page (with Fieldbus Option)
Step 12a: If your IT department gave you settings for a static IP address, enter the appropriate values
for the IP address, subnet mask, and default gateway, then press the Apply button. Power
cycle the Net Box (if you are using PoE, just unplug the Net Box from PoE switch and then
plug it back in). Skip to step 13.
Step 12b: If your IT department gave you settings for DHCP, press the Enabled radio button next to
DHCP and then press the Apply button at the bottom. Power cycle the Net Box (if you are
using PoE, just unplug the Net Box from the PoE switch and then plug it back in).
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 USA • Tel: +1.919.772.0115 • Fax: +1.919.772.8259 • www.ati-ia.com • Email: info@ati-ia.com
B - 23