emerson-300510en-users-manual

System Configuration Manual
300510EN, Rev AA
December 2010
Rosemount Raptor
17. Verify that the TankMaster Level Tag is correct or enter a new one.
18. Verify that the TankMaster ATD Tag is correct or enter a new one.
In case there are no ATD device associated with the tank, the ATD tag
field will be disabled.
19. Click the Install New Devices in TankMaster button to automatically
install the devices in the TankMaster Workspace. This is the
recommended way of installing field devices in TankMaster, but you may
install the devices at a later stage by using the device installation wizard,
see “Using the Device Installation Wizard” on page 5-5.
20. Click the OK button to store the configuration and close the 2410 Tank
Hub configuration window.
21. The devices will now be available in the TankMaster workspace, and
each device has to be configured via the Properties window, see for
example “Installing a Rosemount 5900S Radar Level Gauge” on
page 5-51 and “Installing Auxiliary Tank Devices” on page 5-65.
22. Proceed with installing the tank as described in “Installing a Tank” on
page 5-101.
Now the new tank and field devices are installed and configured and will
appear in the TankMaster workspace.
Section 5. Installing a Raptor Level Gauging System
5-121