Introduction

160
Fertilizers: None registered.
Insecticides: None registered.
Fungicides: None registered.
Note: The above mixes are those listed on the Curtail M label only.
Nufarm Canada supports the following mixes not found on the label. Apply mixes according to the most restrictive use
limitations for either product:
• Wheat Including Durum and Barley: Assert 300SC, Achieve Liquid, Nufarm Tralkoxydim
• Wheat (NOT Durum) and Barley: Axial
• Wheat (NOT Durum): Varro, Everest 2.0, Signal, Fenoxaprop, Traxos, Simplicity
• Flax: Poast Ultra, clethodim (Select/Centurion only)
Adding ingredients in the correct order is critical for optimum performance. Check labels of both products to be mixed for
directions. General guidelines can be found on page 8.
Restrictions:
• Rainfall: Within 6 hours will reduce control.
• Re-entry Interval: DO NOT enter treated fields for at least 12 hours.
• Grazing Restrictions: DO NOT graze treated fields or cut for hay within 7 days of application.
• Pre-harvest Interval: Leave 60 days between application and harvest.
• Re-cropping Interval: Wheat, barley, oats, rye, corn, flax, canola, forage grasses and mustard may be planted the year
after application. DO NOT under-seed crops to forage legumes the year after treatment.
º DO NOT seed to field peas for at least 10 months following treatment. Very dry soil conditions following application
can result in a risk of injury to field peas grown in rotation. If severe drought conditions are experienced during
the months of June to August inclusive in the year of application delay seeding field peas an additional 12 months
(22 months following application). Contact your local Nufarm Agriculture Inc. representative or retailer for more
information before seeding field peas following drought conditions in the previous year.
º DO NOT sow any other crops until the second year after application. Apply manure bedded with straw from treated
crops only to the crops listed above.
• Aerial Application: DO NOT apply by air.
• Storage: Store in a cool (above 5 o C), dry area. If product is frozen, bring to room temperature and agitate before use.
• Buffer Zones:
Application method
Buffer Zones (metres † ) Required for the Protection of:
Aquatic Habitats of Depths
Terrestrial habitat
Less than 1 m
Greater than 1 m
Ground only* 1 1 4
See page 35 for an explanation of the different habitats.
* Buffer zones can be reduced by 70% when using shrouds and by 30% when using cones mounted less than
12 inches from the crop canopy.
†
Distance measured as metres from the downwind edge of the spray boom to sensitive habitat.
Spray when winds are under 16 km/hr, but not dead calm.
Sprayer Cleaning:
No detailed cleaning procedures are indicated on the label. Use a commercial all purpose spray sprayer cleaning product for
adequate cleaning. Contact the manufacturer for more information.
Hazard Rating:
Caution – Poison
Caution – Eye Irritant
For an explanation of the symbols used here see page 4.