Introduction

420
DO NOT apply on soils with > 5% organic matter, or fine soils. Soils such as clay, clay loam, silty clay or silty clay loam are
considered fine textured soils. DO NOT apply to soils composed of more than 90% sand and gravel.
The duration of residual control may be reduced at lower rates. Spray within 6 hours of mixing.
Application Information:
• Water Volume: Minimum application volume is not indicated on the label. Use appropriate water volumes to ensure
good spray coverage.
• Nozzles and Pressure: Use a combination of nozzles and pressure designed to deliver thorough, even coverage with
ASABE medium droplets.
• Screens: The use of 50 mesh screens is recommended.
• DO NOT perform any tillage operations after application otherwise weed control will be reduced. When applied prior
to seeding crops must be direct seeded with minimum disturbance systems.
How it Works:
Refer to Table 9 on page 48.
Effects of Growing Conditions:
Rainfall is required to activate flumioxazin in the soil. Crop injury may occur when soils are wet and cool following
application or soils are poorly drained. Severe injury may occur with flooded soils. Newly emerging foliage can be
temporarily injured by heavy rain splashing treated soil on leaves. Heavy crop residues may reduce weed control
Irrigation: If rainfall is not received after application, 5 to 10 mm of irrigation may be applied to improve weed control
activity. DO NOT apply irrigation to wheat after emergence until the main head is fully emerged.
Tank Mixes:
The following mixes are for Valtera only.
Herbicides:
• Soybean, Wheat or Bare Ground:
º Glyphosate (IPA or K salts) 180 to 486 g ae per acre. (spring or fall)
º Note: DO NOT mix when applying prior to soybean with Dual II Magnum or Frontier/Outlook herbicides or injury
could occur.
• Field pea and chickpea (spring or fall) and lentil (fall only):
º Glyphosate (IPA or K salts) 180 to 360 g ae per acre.
• Dry Bean Desiccation only:
º Glyphosate (IPA or K salts) at preharvest rates.
Fertilizers: None registered.
Fungicides: None registered.
Insecticides: None registered.
Note: The above mixes are those listed on the Valtera label only.
Nufarm Agriculture also supports the following mixes that are not on the Valtera label. Apply mixes according to the
most restrictive use limitations for either product:
• Herbicides:
º Soybean, Spring wheat: BlackHawk
º Field pea, Spring wheat: GoldWing
Adding ingredients in the correct order is critical for optimum performance. Check labels of products to be mixed for
directions. General guidelines can be found on page 8.
Restrictions:
• Rainfall: Rain or irrigation shortly after application is required for activation. If rainfall does not occur, irrigation with at
least 5 mm of water is recommended before ground crack occurs.
• Re-entry Interval: DO NOT re-enter treated fields for 12 hours.