Introduction

220
How it Works:
Refer to Table 9 on page 48.
Effects of Growing Conditions:
The activity these products are influenced by weather conditions. The temperature range for optimum activity is 12 o C to
24 o C. Reduced activity will occur when temperatures are below 8 o C or above 27 o C. Frost 3 days before or after application
may reduce weed control and crop tolerance. Weed control may be reduced during stress conditions (drought, heat or cold
stress) or if extremely heavy infestations exist.
Tank Mixes:
Tank mix partners applied at all label rates and include recommended adjuvants unless otherwise noted.
Herbicides:
The following mixes may be used with each of the combinations above unless noted otherwise.
• In spring wheat (including durum) and barley:
º Assert (0.53 to 0.65 L per acre)
º Tralkoxydim † *
• In spring wheat (including durum) only:
º Clodinafop 240EC † (93 mL per acre)
º Fenoxaprop (Bengal with Rush 24 only)
º Simplicity ††
º Simplicity GoDRI
Insecticides: None registered.
Fungicides: None registered.
Fertilizer: None registered.
* Temporary crop injury or reduced wild oat control may occur with this tank mix.
†
See product labels for specific brands registered.
††
OcTTain XL without additional 2,4-D ester only or low rate of Attain XC.
Note: The above mixes are those listed on the fluroxypyr + 2,4-D product labels only.
Manufacturers may also support mixes between their products and other pesticides that are not on their labels. Check
with each manufacturer for the products they support. Mixes must be applied according to the most restrictive use
limitations for all products added to the tank.
Adding ingredients in the correct order is critical for optimum performance. Check labels of products to be mixed for
directions. General guidelines can be found on page 8.
Restrictions:
• Rainfall:
º Attain XC and Flurox 2,4: Within 2 hours will reduce control.
º OcTTain XL: Wet foliage at application will reduce control.
• Re-entry Interval: DO NOT re-enter treated area within 12 hours.
• Grazing Restrictions: DO NOT permit lactating dairy animals to graze cereal fields within 7 days of application.
DO NOT harvest cereal crops for forage or cut hay within 30 days of application. Withdraw meat animals from treated
fields at least 3 days before slaughter. DO NOT feed or cut forage grasses for hay
• Pre-harvest Interval: Leave 60 days between application and harvest.
• Re-cropping Interval: Barley, canola, flax, forage grasses, lentils, mustard, oats, peas, rye, and wheat, may be grown
the year after application. Alfalfa, corn, dry beans, potatoes, soybeans, and sunflowers may also be seeded the year
following Attain XC and OcTTain XL only. There are no re-cropping restrictions the second year after application.
• Aerial Application: Attain XC and OcTTain XL may be applied by air.
• Storage: Avoid freezing. If frozen, bring to room temperature and agitate before use. These products are combustible.
DO NOT store near heat or open flame.