Introduction

216
Application Information:
• Water Volume:
º Ground: 22.5 to 45 L per acre.
º Aerial: 11 L per acre.
• Nozzles and Pressure: Use 30 to 50 psi (200 to 345 kPa) when using conventional flat fan nozzles. Low drift nozzles
may require higher pressures for proper performance. Use a combination of nozzles and pressure designed to deliver
thorough, even coverage with ASABE medium droplets. Orienting nozzles at a 45 degree angle forward may improve
coverage of vertical leaves (grasses).
How it Works:
Refer to Table 9 on page 48.
Effects of Growing Conditions:
Crop tolerance and weed control may be reduced if applications are made to plants growing under stress. Stress includes
saturated or water-logged soil, drought, extreme temperatures, low fertility or visible disease symptoms at application.
Adopting practices to increase crop vigour will improve crop tolerance.
Tank Mixes:
Herbicides:
Note:
• All mixes must be applied with a registered surfactant unless otherwise indicated. Only one registered surfactant is
required.
• All products below may be mixed at label rates with Flucarbazone unless otherwise indicated.
• Flucarbazone at all rates may be mixed with the products listed below unless otherwise indicated.
• In wheat (spring and durum) only:
º 2,4-D Amine or Ester
(rates up to 170 g ae
per acre*
• In wheat (spring and winter) only:
º 2,4-D Amine or Ester
up to 227 g ae per
acre
º Enforcer M
º Florasulam +
Curtail M (Spectrum
only)*
º Bromoxynil/MCPA
(Buctril M/Logic M
only)
• In spring wheat (NOT including durum) only:
º Bromoxynil (Brotex
º Dichorprop+2,4-D
240/Pardner only)
(Estaprop/
º Bromoxynil/2,4-D
Dichlorprop-D only
(Leader/Thumper
º Florasulam + 2,4-D
only)
(Frontline 2,4-D only)
º Curtail M # *
Florasulam + MCPA
º Dicamba/mecoprop/
(Frontline XL only)*
MCPA (Target
º Florasulam/
only) ##† *
Fluroxypyr+MCPA
(Stellar only)#*
*Apply in 40 L per acre of water only.
†
Wild oat control may be reduced with this mix.
#
Tank mix only with the 24.3 to 29.1 mL per acre rate of flucarbazone.
##
Tank mix only with the 29.1 mL per acre rate of flucarbazone.
Fertilizers: None.
Insecticides: None
Note: The above mixes are those listed on the flucarbazone labels only.
º Paradigm
º Paradigm + MCPA
Ester
º MCPA Amine or
Ester at rates up to
0.38 L per acre (600
g/L formulation)
º Fluroxypyr + 2,4-D
(Attain XC, OcTTain
XL only)#*
º Fluroxypyr+MCPA
(Trophy only)
º Metsulfuron (Ally
only) + 2,4-D Amine
or Ester up to rates
above*
º Paradigm + Curtail M
º Pixxaro
º Thifensulfuron/
tribenuron (Refine
SG/Deploy WDG only)
º Optica Trio ## *
º Prestige XC # *
º Thifensulfuron/
Tribenuron (Refine
SG /Deploy only) plus
2,4-D Amine or Ester
at rates above
º Triton C