Introduction

209
Supported unlabelled mixes - Apply mixes according to the most restrictive use limitations for either product:
• Dow AgroSciences supports the following mixes that are not on the PrePass label:
º Herbicides: 2,4-D ester, MCPA ester, VP-480. Additional glyphosate with an IPA or DMA salt may be added up to
1020 gae per acre**. (see glyphosate page for rate details)
** NOTE: Dow AgroSciences does not support the topping up of PrePass XC with other salts of glyphosate as
they may have a negative reaction with the florasulam component. PrePass Flex may be topped up with any
formulation of glyphosate, as indicated above.
• ADAMA supports the following mixes that are not on the Priority label.
º Herbicides: glyphosate (all salts).
Adding ingredients in the correct order is critical for optimum performance. Check labels of products to be mixed for
directions. General guidelines can be found on page 8.
Restrictions:
• Rainfall: Heavy rainfall immediately after application may wash the chemical off the foliage. DO NOT apply if rainfall
is forecast for the time of application. Contact manufacturer for more information. DO NOT apply excessive irrigation
following application as product may leach.
• Re-entry Interval: DO NOT enter treated fields for at least 12 hours.
• Grazing Restrictions: DO NOT graze treated crop or cut for feed within 7 days of application.
• Re-cropping Interval: Spring wheat (including durum), barley and oat, may be seeded, or the field may be fallowed,
after applications made in the spring prior to seeding, or the previous year after August 1. Barley, canola, chickpeas*,
dry beans*, field peas, flax*, lentils*, mustard* (brown, oriental, yellow and oilseed quality B. juncea) oat, soybeans*,
sunflower* and wheat, may be grown following applications made prior to August 1 of the previous season.
* PrePass XC, PrePass Flex, and Priority only.
• Aerial Application:
• Aerial Application: DO NOT apply by air.
• Storage: Store in dry, heated area. DO NOT freeze.
• Buffer Zones:
Application method
Buffer Zones (metres † ) Required for the Protection of:
Aquatic Habitats of Depths
Terrestrial habitat
Less than 1 m
Greater than 1 m
Ground only* 15 15 30
See page 35 for an explanation of the different habitats.
* Buffer zones can be reduced by 70% when using shrouds and by 30% when using cones mounted less than
12 inches from the crop canopy.
†
Distance measured as metres from the downwind edge of the spray boom to sensitive habitat.
Weed Control
Sprayer Cleaning:
Refer to ‘Method A’ in the general section on sprayer cleaning on page 9 and 10.
Hazard Rating:
Caution – Poison
Caution – Irritant, may cause eye irritation.
For an explanation of the symbols used here see page 4.