Introduction

179
Effects of Growing Conditions:
For best weed control, apply when temperature is between 10 and 25 o C. DO NOT treat crops under stress from excessive
moisture or drought. To avoid crop injury, DO NOT apply when temperature is expected to exceed 30 o C, or when there is a
risk of a severe drop in overnight temperature.
Tank Mixes:
None registered.
Note: No mixes are listed on the DyVel label with currently marketed products.
Adding ingredients in the correct order is critical for optimum performance. Check labels of products to be mixed for
directions. General guidelines can be found on page 8.
Restrictions:
• Rainfall: No rainfast period is specified on the label; required interval may be up to 8 hours. Avoid applying this
product when heavy rain is forecast. Contact manufacturer for more information.
• Re-entry Interval: DO NOT enter treated fields for at least 12 hours.
• Grazing Restrictions: DO NOT graze treated crop or cut for hay within 30 days of application.
• Pre-harvest Interval: Leave 60 days between application and harvest.
• Re-cropping Interval: No restrictions the year after treatment.
• Aerial Application: May be applied by air.
• Storage: May be frozen.
• Buffer Zones:
Application method
Buffer Zones (metres † ) Required for the Protection of:
Aquatic Habitats of Depths
Terrestrial habitat
Less than 1 m
Greater than 1 m
Ground only* 1 1 4
Fixed wing aircraft 1 0 60
Helicopter 1 0 50
See page 35 for an explanation of the different habitats.
* Buffer zones can be reduced by 70% when using shrouds and by 30% when using cones mounted less than
12 inches from the crop canopy.
†
Distance measured as metres from the downwind edge of the spray boom to sensitive habitat.
Weed Control
Sprayer Cleaning:
Refer to “Method A” in the general sprayer cleaning section on page 9 and 10. If mixed with other pesticides, the cleaning
method above should be combined with the method recommended for the tank mix partner if different from above.
Hazard Rating:
Caution – Poison
For an explanation of the symbols used here see page 4.