Introduction

270
Weeds, Rates, Staging:
At the Infinity 335 mL per acre and FX 160 mL ( one case treats 40 acres) the weed species controlled by the Infinity label
plus the following at the 1 to 6 leaf stage.
º Cleavers (1 to 9
whorls)*
º Kochia (up to 15 cm in
height)
º Volunteer flax (up to
12 cm)
* Ammonium sulphate at 200 g of active ingredient per acre may be added for improved broad leaf control (202 g
per acre of 99% dry; 0.5 L per acre of 40% liquid; or 0.4L per acre of 49% liquid).
Application Information
• Water Volume
º Ground: Minimum of 19 L per acre . Higher water volumes should be used under dense crop and weed canopies
to ensure thorough coverage of the target weed.
• Nozzles and Pressure: Maximum 40 to 45 psi (275 to 310 kPa) with conventional flat fan nozzles. Use nozzles
and pressure to deliver proper coverage with ASABE medium droplets. Angle ground sprayer nozzles forward at a
45° angle to improve coverage of vertical leaf targets.
How it works
Refer to Table 9 on page 48
Effects of Growing Conditions
For best results, apply to emerged, young, actively growing weeds according to the weed stages listed. Under stressed
conditions and/or heavy crop canopy, early application will result in improved weed control. Weeds growing under adverse
environmental conditions such as drought will be less susceptible to herbicide effects.
Tank Mixes
Tank mix partners applied at all label rates and include recommended adjuvants unless otherwise noted.
Herbicides :
• Spring wheat, durum, and barley:
º 2,4-D ester + AMS
º Liquid Achieve
º Puma Advance
• Spring wheat and durum:
º Horizon NG
º Varro
• Spring wheat
º Axial
Insecticides: None registered
Fungicide: None registered
Fertilizers: DO NOT mix fertilizers other than those indicated above
Bayer also supports the following mixes that are not on the Infinity FX label. Apply mixes according to the most
restrictive use limitations for either product:
• Herbicides: 2,4 D ester, MCPA ester
Adding ingredients in the correct order is critical for optimum performance. Check label of both products to be mixed for
directions. General guidelines can be found on page 8.
Restrictions
• Rainfall: Within 1 hour of application may reduce control.
• Re-entry Interval: DO NOT re-enter treated field until 12 hours post-application.
• Grazing Restrictions: DO NOT graze treated crops or cut for hay within 25 days of application
• Pre-harvest Interval: leave at least 50 days for wheat and durum and 45 days for barley from application to harvest of
grain or straw.