Introduction

189
Enforcer M (this referring text to be removed in the 2019 edition)
See Bromoxynil + MCPA + Fluroxypyr on page 138.
Enforcer MSU
This product is the equivalent of a prepackaged mix of Enforcer M
(bromoxynil+MCPA+fluroxypyr - page 138) and Boost (thifensulfuron/tribenuron
75WDG – see page 378). Information listed is restricted to Crops, Weeds and Rates.
For other detailed information on the component products see the product pages
listed for the components.
Company:
Nufarm Agriculture
Herbicide Group
2 – thifensulfuron/
tribenuron
4 – fluroxypyr and MCPA
6 - bromoxynil
(Refer to page 44)
Weed Control
Formulation:
The Enforcer MSU package has two components:
Enforcer M (PCP#30691): 80 g/L fluroxypyr, 200 g/L bromoxynil and 200 g/L MCPA ester formulated as an emulsifiable
concentrate.
• Container size – 2 x 7.5 L
Boost (PCP#30377): 50% thifensulfuron and 25% tribenuron formulated as a water dispersible granule.
• Container size – 108 g
Crops and Staging:
Wheat (durum, spring) and barley: 2 leaf up until the flag leaf is fully emerged.
Winter wheat: in spring from fully tillered up until the flag leaf is fully emerged.
When tank mixing, always check the tank mix partner recommendations for additional staging restrictions.
Weeds and Staging:
Weeds controlled by Enforcer M plus suppression of narrow-leaved hawk’s-beard.
Rates:
Enforcer M: 375 mL per acre
Boost: 2.71 g per acre
(One case treats 40 acres)
Refer to the product label for complete mixing instructions. A general guide to mixing can be found on page 8.
Tank Mixes:
None registered.
Nufarm Agriculture also supports the following mixes that are not on the Enforcer M and Boost labels. Apply mixes
according to the most restrictive use limitations for either product:
• Herbicides: Axial, Cordon (Fenoxaprop), Everest 2.0, Signal (clodinafop), Simplicity, Traxos, Varro,
Note: Enforcer MSU SHOULD NOT be tank-mixed with Tralkoxydim (Nufarm Tralkoxydim or Liquid Achieve), as reduced grass
control may occur.